Alkenes can be obtained from amines via an E2 elimination. The amine is first converted into a good leaving group, such as a quaternary ammonium salt. This is accomplished by treating the amine with an excess of alkyl halide, which results in a halide salt. Next, the halide salt is transformed into a hydroxide salt that functions as a base to enable elimination.
Under thermal conditions, the hydroxide can abstract a proton from the β carbon; this generates an alkene with the simultaneous...

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.

In calculus, the computation of the area under a continuous curve has been fundamentally simplified by applying the Fundamental Theorem of Calculus, Part 2. Rather than relying on the limiting process of summing infinitely many infinitesimal rectangles, this theorem permits direct evaluation using antiderivatives, thereby streamlining the process of definite integration.The Fundamental Theorem of Calculus, Part 2, states that if a function f(x) is continuous on a closed interval [a, b], then...

The Frost circle or the inscribed polygon method is a graphical method for determining the relative energies of π molecular orbitals (MOs) for planar, fully conjugated, and monocyclic compounds. This method was first described by A. A. Frost and Boris Musulin in 1953.
A Frost circle is constructed by drawing a polygon whose number of edges is equal to the number of carbons of the given cyclic system, with one of the vertices pointing down. Then, a circle is drawn enclosing the polygon so...

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and...

To determine the electron configuration for any particular atom, we can build the structures in the order of atomic numbers. Beginning with hydrogen, and continuing across the periods of the periodic table, we add one proton at a time to the nucleus and one electron to the proper subshell until we have described the electron configurations of all the elements. This procedure is called the aufbau principle, from the German word aufbau (“to build up”). Each added electron occupies the...