Offshore platforms: comparison of five benthic indicators for assessing the macrozoobenthic stress levels

A Spagnolo1, E Punzo1, A Santelli1

  • 1National Council of Researches - Institute of Marine Sciences (CNR-ISMAR), L.go Fiera della Pesca, 60125 Ancona, Italy.

Related Concept Videos

Marine Microbial Ecology01:30

Marine Microbial Ecology

Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...
66
Deep Sea Microbial Ecology01:18

Deep Sea Microbial Ecology

The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches...
53
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
834
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
813