A comprehensive laboratory screening of three-step etch-and-rinse adhesives

This study evaluated several bonding (microtensile bond strengths [μTBS], nanoleakage [NL], and in situ degree of conversion [ISDC] on dentin) and mechanical properties (ultimate tensile strength [UTS], degree of conversion [DC], water sorption [WS], and solubility [SL] in water) of four three-step etch-and-rinse adhesives in the short term.

A total of 28 molars were used in this study. The dentin surfaces were bonded with the following adhesives: All-Bond 3 (ALB3); Fusion Duralink (FSDL); Optibond FL (OBFL), and Scotchbond Multi-Purpose (SBMP). After each adhesive-system application, composite resin build-ups were added. For bonding tests, specimens were sectioned in order to obtain bonded sticks. The sticks were divided to be tested for μTBS (0.5 mm/min), for NL (n=2), and ISDC (n=2). For NL, they were immersed in 50% silver nitrate and analyzed by scanning election microscopy. For ISDC, the hybrid layer was evaluated by micro-Raman spectroscopy. An hourglass-shaped matrix (UTS) or disk-shaped matrix (WS and SL) was filled with primer and adhesive (1:1 ratio) and light-polymerized. For UTS evaluation, the specimens were tested under tension. For WS and SL, specimens were desiccated and stored in distilled water to evaluate water diffusion kinetics over a 28-day period. The DC of the adhesives was evaluated by Fourier transformed infrared spectroscopy. The data from each test were analyzed by appropriate statistical methods.

OBFL resulted in the highest μTBS, lower NL, higher ISDC and DC, and higher UTS than other adhesives (p<0.05), as well as lower WS (similar to ALB3 and FSDL) and SL (similar to ALB3 and SBMP) (p>0.05). ALB3 showed a higher NL and the lowest DC value. FSDL showed the highest NL and SL and the lowest ISDC. SBMP showed the lowest pattern of WS (p<0.05)CONCLUSION: OBFL showed the best results in all the properties evaluated, and it can be considered the gold standard of the three-step etch-and-rinse adhesive systems.