Related Experiment Video
Updated: May 1, 2026

Physical, Chemical and Biological Characterization of Six Biochars Produced for the Remediation of Contaminated Sites
Published on: November 28, 2014
Surface properties and chemical composition of corncob and miscanthus biochars: effects of production temperature and
Alice Budai1, Liang Wang, Morten Gronli
1Soil and Environment Division, Bioforsk - Norwegian Institute for Agricultural and Environmental Research , Frederik A. Dahl vei 20, 1430 Ås, Norway.
Abstract:
Biochar properties vary, and characterization of biochars is necessary for assessing their potential to sequester carbon and improve soil functions. This study aimed at assessing key surface properties of agronomic relevance for products from slow pyrolysis at 250-800 °C, hydrothermal carbonization (HTC), and flash carbonization. The study further aimed at relating surface properties to current characterization indicators. The results suggest that biochar chemical composition can be inferred from volatile matter (VM) and is consistent for corncob and miscanthus feedstocks and for the three tested production methods. High surface area was reached within a narrow temperature range around 600 °C, whereas cation exchange capacity (CEC) peaked at lower temperatures. CEC and pH values of HTC chars differed from those of slow pyrolysis biochars. Neither CEC nor surface area correlated well with VM or atomic ratios. These results suggest that VM and atomic ratios H/C and O/C are good indicators of the degree of carbonization but poor predictors of the agronomic properties of biochar.
Related Concept Videos
Effect of Temperature Change on Reaction Rate
Combustion Energy: A Measure of Stability in Alkanes and Cycloalkanes
Alkanes undergo combustion in the presence of excess oxygen and high-temperature conditions to give carbon dioxide and water. A combustion reaction is the energy source in natural gas, liquified...
Thermochemical Equations
Thermal Sigmatropic Reactions: Overview
Sigmatropic shifts are classified based on an order term [i, j ], where i and j indicate the number of atoms across which each end of the σ bond migrates. Below are examples of a [3,3] sigmatropic shift in...
Effects of Temperature on Free Energy
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...

