Related Experiment Video
Updated: Apr 30, 2026

Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample
Published on: March 21, 2016
Temperature and moisture dependence of the dielectric properties of silica sand
Abstract:
The major objective of this work was to investigate the effects of temperature and moisture content on the dielectric properties of silica sand. The dielectric properties of moist silica sand at five temperatures between 20 to 100 degrees C, covering different moisture content levels at a frequency of 2.45 GHz, were measured with an open-ended coaxial probe dielectric measurement system. The wave penetration depth was calculated based on the measured dielectric data. The results show moisture content to be the major influencing factor for the variation of dielectric properties. Dielectric constant, loss factor and loss tangent all increase linearly with increasing moisture content. Three predictive empirical models were developed to relate the dielectric constant, loss factor, loss tangent of silica sand as a linear function of moisture content. An increase in temperature between 20 to 100 degrees C was found to increase the dielectric constant and loss factor. The penetration depth decreased with increase in moisture content and temperature. Variation in penetration depth was found to vary linearly with decrease in moisture content. An predictive empirical model was developed to calculate penetration depth for silica sand. This study offers useful information on dielectric properties of silica sand for developing microwave drying applications in mineral processing towards designing better microwave sensors for measuring silica sand moisture content.
Related Concept Videos
Specific Heat
For example, increasing the temperature of one gram of water by 1°C requires one calorie of heat energy and can be written as 1 cal/g-°C, or...
Susceptibility, Permittivity and Dielectric Constant
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Fineness Modulus
Consider performing sieve analysis on sand through a set of ASTM sieves. The weight of aggregate retained in each sieve and pan placed at the bottom is recorded, as given in Column B of Table 1.
To determine the fineness modulus of...
Silica Gel Column Chromatography: Overview
Polar components tend to bind strongly to the silica gel, causing them to move slowly through the column. In contrast, nonpolar compounds...

