Related Experiment Video

Updated: Apr 30, 2026

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework
11:38

In situ FTIR Spectroscopy as a Tool for Investigation of Gas/Solid Interaction: Water-Enhanced CO2 Adsorption in UiO-66 Metal-Organic Framework

Published on: February 1, 2020

16.8K

A comparative ultrasonic relaxation study of lower vicinal and terminal alkanediols at 298.15 K in relation to their

Edward Zorębski1, Michał Zorębski

  • 1Institute of Chemistry, Silesian University , Szkolna 9, 40-006 Katowice, Poland.

The Journal of Physical Chemistry. B
|May 9, 2014
PubMed

More Related Videos

Vibrational Spectra of a N719-Chromophore/Titania Interface from Empirical-Potential Molecular-Dynamics Simulation, Solvated by a Room Temperature Ionic Liquid08:54

Vibrational Spectra of a N719-Chromophore/Titania Interface from Empirical-Potential Molecular-Dynamics Simulation, Solvated by a Room Temperature Ionic Liquid

Published on: January 25, 2020

5.0K
Spatial Separation of Molecular Conformers and Clusters10:37

Spatial Separation of Molecular Conformers and Clusters

Published on: January 9, 2014

11.0K

Related Concept Videos

Relative Stabilities of Alkenes01:59

Relative Stabilities of Alkenes

The relative stability of alkenes can be determined by comparing their heats of hydrogenation. The lower heat of hydrogenation indicates the more stable alkene.  The three main factors determining the relative stability of alkenes are i) the number of substituents attached to the double-bond carbon atoms, ii) hyperconjugation, and iii) the stereochemistry of the double bond.
12.7K
IR Spectrum Peak Broadening: Hydrogen Bonding01:23

IR Spectrum Peak Broadening: Hydrogen Bonding

The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular...
1.9K
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are...
7.0K
IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

IR and UV–Vis Spectroscopy of Aldehydes and Ketones

Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the...
5.1K
IR Frequency Region: Alkyne and Nitrile Stretching01:22

IR Frequency Region: Alkyne and Nitrile Stretching

Both alkyne (C≡C) and nitrile (C≡N) functional groups contain triple bonds and show stretching absorptions around the wavenumber range of 2100 to 2300 cm−1 in the diagnostic region of the IR spectra.
Comparing the stretching vibrational frequency of  C≡C triple bonds with that of double and single bonds, it is evident that C≡C triple bonds exhibit a higher stretching frequency than C=C double and C–C single bonds. Similarly, the C≡N triple bond...
1.5K
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
11.7K