A comparative evaluation of the dimensional accuracy of heat polymerised PMMA denture base cured by different curing...

The aim of this study is to evaluate the dimensional accuracy of heat polymerized PMMA denture base clamped by the conventional method and by R.S technique and cured by a different curing cycle.

In this study, a total of 40 standardized maxillary record bases were fabricated with seven reference points: Point A - Incisive papilla, Point B & C - Canine region on either side, Point E & G - Midpoint of tuberosities on either side, Point F- Midpoint of the line joining the two tuberosities, Point D- Midpoint between the line joining A and F. Group A: Ten maxillary record bases were fabricated by conventional clamping method and cured by long curing cycle. Group A1: Ten maxillary record bases were fabricated by R.S tension clamping method and cured by long curing cycle. Group B: Ten maxillary record bases were fabricated by conventional clamping method and cured by short curing cycle. Group B1: Ten maxillary record bases were fabricated by R.S tension clamping method and cured by short curing cycle. The distances between the reference points i.e. A-B, A-C, A-D, D-F, B-E, C-G, E-F, F-G, B-D, D-G, CD, D-E of all three thermoplastic denture base plates were measured and recorded with the help of a travelling microscope and were used for comparison with the measured and recorded readings of processed acrylic denture bases. The data obtained was analyzed by using the One Way Analysis of Variance.

The overall results of the in vitro study indicate that among all the PMMA bases cured by the two clamping systems and the different curing cycle, group A` was the most dimensionally stable, followed by control group A, then followed by B` and B was most unstable.

The study concluded that the denture bases fabricated by the R.S Technique using the long curing cycle would produce the most dimensionally stable PMMA denture bases. How to cite the article: Babu MR, Rao CS, Ahmed ST, Bharat JS, Rao NV, Vinod V. A comparative evaluation of the dimensional accuracy of heat polymerised PMMA denture base cured by different curing cycles and clamped by R S technique and conventional method - An In-vitro study. J Int Oral Health 2014;6(2):68-75.