Velocity and position can be calculated from the known function of acceleration as a function of time. The total area under the acceleration-time graph and the velocity-time graph gives the change in velocity and position, respectively. In the case of an airplane, its acceleration is tracked using the inertial navigation system. The pilot provides the input of the airplane's initial position and velocity before takeoff. The inertial navigation system then uses the acceleration data to...

Every measurement provides three kinds of information: the size or magnitude of the measurement (a number), a standard of comparison for the measurement (a unit), and an indication of the uncertainty of the measurement. While the number and unit are explicitly represented when a quantity is written, the uncertainty is an aspect of the errors in the measurement results.

The International System of Units or SI system, by international agreement, has fixed measurement units for seven fundamental properties: length, mass, time, temperature, electric current, amount of substance, and luminosity. These are called the SI base units.

Data are individual items of information obtained from a population or sample. Data may be classified as qualitative (categorical), quantitative continuous, or quantitative discrete. Because it is not practical to measure the entire population in a study, researchers use samples to represent the population. A random sample is a representative group from the population chosen by using a method that gives each individual in the population an equal chance of being included in the sample. Random...

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...

Measuring how one directional quantity affects another along a specific path involves comparing their orientation and strength. When two such quantities are represented using direction and amount, a numerical result is computed to show how much one acts along the path of the other. This result comes from a rule combining both inputs' horizontal and vertical parts and adding the results.This calculation gives a single value that grows larger when both inputs point in similar directions and...