Group membership prediction when known groups consist of unknown subgroups: a Monte Carlo comparison of methods

W Holmes Finch1, Jocelyn H Bolin1, Ken Kelley2

  • 1Department of Educational Psychology, Ball State University Muncie, IN, USA.

Related Concept Videos

Comparing the Survival Analysis of Two or More Groups01:20

Comparing the Survival Analysis of Two or More Groups

Survival analysis is a cornerstone of medical research, used to evaluate the time until an event of interest occurs, such as death, disease recurrence, or recovery. Unlike standard statistical methods, survival analysis is particularly adept at handling censored data—instances where the event has not occurred for some participants by the end of the study or remains unobserved. To address these unique challenges, specialized techniques like the Kaplan-Meier estimator, log-rank test, and...
712
Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
3.4K
Prediction Intervals01:03

Prediction Intervals

The interval estimate of any variable is known as the prediction interval. It helps decide if a point estimate is dependable.
However, the point estimate is most likely not the exact value of the population parameter, but close to it. After calculating point estimates, we construct interval estimates, called confidence intervals or prediction intervals. This prediction interval comprises a range of values unlike the point estimate and is a better predictor of the observed sample value, y. 
2.5K
Aggregates Classification01:29

Aggregates Classification

Aggregate classification is generally based on its size, petrographic characteristics, weight, and source. Size classification ranges from coarse to fine aggregates, defined by the size of the particles. Coarse aggregates are particles that do not pass through ASTM sieve No. 4, and aggregates that pass through the sieve are fine aggregates.
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
1.0K
Quantifying and Rejecting Outliers: The Grubbs Test01:02

Quantifying and Rejecting Outliers: The Grubbs Test

Sometimes, a data set can have a recorded numerical observation that greatly  deviates from the rest of the data. Assuming that the data is normally distributed, a statistical method called the Grubbs test can be used to determine whether the observation is truly an outlier.  To perform a two-tailed Grubbs test, first, calculate the absolute difference between the outlier and the mean. Then, calculate the ratio between this difference and the standard deviation of the sample. This...
4.0K
Wilcoxon Signed-Ranks Test for Matched Pairs01:09

Wilcoxon Signed-Ranks Test for Matched Pairs

The Wilcoxon signed-rank test for matched pairs evaluates the null hypothesis by combining the ranks of differences with their signs. It essentially tests whether the median of the differences in a population of matched pairs is zero. Since the test incorporates more information than the sign test, it generally yields more trustable conclusions. This test also does not require the data to follow a normal distribution, but two conditions must be met for it to be applicable: (1) the data must...
624