Effectiveness of spray congealing to obtain physically stabilized amorphous dispersions of a poorly soluble...

An amorphous phase produced by micronization up to the molecular or colloidal level of a poorly soluble drug having low lipophilicity can distinctly enhance its solubility characteristics. However, though dispersing the molten mass of a poorly water-soluble drug within polymeric matrix has been found to be most effective in formation of molecular dispersions, the drug molecules which melt at high temperature also accompanied by decomposition, such as acetazolamide, are difficult to formulate as molecular dispersions. Hence, a method is proposed to obtain molecular dispersions of acetazolamide with poloxamer-237 by spray congealing under optimal heat treatment. Uniform molecular and/or colloidal dispersions of the drug were achieved with instantaneous solvent evaporation by mixing a drug solution with molten mass of the plasticizer matrix. Immobilization of dispersed drug molecules was effected subsequently through rapid solidification by spray congealing. Initial characterization of 1:1, 1:1.5, and 1:2 ratios of solid dispersions and devitrification study of an optimized (1:2) ratio ensured efficacy of the proposed method in formation of physically stabilized amorphous systems without thermal degradation and hence resulted in more than ninefold rise in solubility and more than 90% dissolution within initial 10 min. With 1:2 ratio, molecular dispersions could be achieved by initial solvent evaporation stage, which when subjected to spray congealing produced physically stable amorphous systems, without signs of thermal degradation. This study also proposes an opportunity for selection of those polymers with which the drug is immiscible in their fluid state, yet obtaining molecular dispersions.