Influence of softening test and light-activation protocols on resin composite polymer structure

This study analyzed the influences of the light-activation protocol and softening test on the degree of conversion (DC) and Knoop Hardness (KHN) of a microhybrid resin composite.

Filtek Z250 (3M ESPE) was light-activated with a third-generation light-emitting diode (Valo Ultradent) by three protocols - standard, high power, and plasma emulation - or with a quartz-tungsten halogen XL 3000 (3M ESPE) in conventional mode. All modes were set to deliver 19 J/cm(2). The DC (N = 20) was determined by Fourier transform infrared spectrometry on the top (T) and bottom (B) surfaces. For the KHN test, samples were subdivided in four groups (n = 5 each) according to the storage media: absolute ethanol, 75% ethanol, distilled water, and air (control group). The KHN values were evaluated on T and B before and 24 h after immersion in the storage media. Data were analyzed by split-plot analysis of variance (ANOVA; for DC) or repeated-measures split-plot ANOVA (for KHN), followed by Tukey's test (α = 0.05).

For the DC, the light-activation protocol did not influence the results and there was no difference between T and B. For the KHN test, the light-activation protocol did not influence the results and T showed higher microhardness values than B for all experimental conditions. There were significant differences in KHN depending on the storage media. Samples immersed in absolute ethanol generally presented lower KHN values, with no differences compared to samples in 75% ethanol.

The storage media affected the outcomes of the softening test.