Related Experiment Video

Updated: Apr 27, 2026

Measuring 3D In-vivo Shoulder Kinematics using Biplanar Videoradiography

Measuring 3D In-vivo Shoulder Kinematics using Biplanar Videoradiography

Published on: March 12, 2021

Acromioclavicular joint dislocations: radiological correlation between Rockwood classification system and injury

Anica Eschler¹, Klaus Rösler, Robert Rotter

¹Department of Trauma, Hand and Reconstructive Surgery, Medical Center, University of Rostock, Schillingallee 35, 18057, Rostock, Germany, anica.eschler@med.uni-rostock.de.

Archives of Orthopaedic and Trauma Surgery

|July 5, 2014

Abstract

Introduction:

The classification system of Rockwood and Young is a commonly used classification for acromioclavicular joint separations subdividing types I-VI. This classification hypothesizes specific lesions to anatomical structures (acromioclavicular and coracoclavicular ligaments, capsule, attached muscles) leading to the injury. In recent literature, our understanding for anatomical correlates leading to the radiological-based Rockwood classification is questioned. The goal of this experimental-based investigation was to approve the correlation between the anatomical injury pattern and the Rockwood classification.

Materials And Methods:

In four human cadavers (seven shoulders), the acromioclavicular and coracoclavicular ligaments were transected stepwise. Radiological correlates were recorded (Zanca view) with 15-kg longitudinal tension applied at the wrist. The resulting acromio- and coracoclavicular distances were measured.

Results:

Radiographs after acromioclavicular ligament transection showed joint space enlargement (8.6 ± 0.3 vs. 3.1 ± 0.5 mm, p < 0.05) and no significant change in coracoclavicular distance (10.4 ± 0.9 vs. 10.0 ± 0.8 mm). According to the Rockwood classification only type I and II lesions occurred. After additional coracoclavicular ligament cut, the acromioclavicular joint space width increased to 16.7 ± 2.7 vs. 8.6 ± 0.3 mm, p < 0.05. The mean coracoclavicular distance increased to 20.6 ± 2.1 mm resulting in type III-V lesions concerning the Rockwood classification.

Conclusions:

Trauma with intact coracoclavicular ligaments did not result in acromioclavicular joint lesions higher than Rockwood type I and II. The clinical consequence for reconstruction of low-grade injuries might be a solely surgical approach for the acromioclavicular ligaments or conservative treatment. High-grade injuries were always based on additional structural damage to the coracoclavicular ligaments. Rockwood type V lesions occurred while muscle attachments were intact.

More Related Videos

Measurement of Dynamic Scapular Kinematics Using an Acromion Marker Cluster to Minimize Skin Movement Artifact

Measurement of Dynamic Scapular Kinematics Using an Acromion Marker Cluster to Minimize Skin Movement Artifact

Published on: February 10, 2015

Anterior Cruciate Ligament Transection and Synovial Fluid Lavage in a Rodent Model to Study Joint Inflammation and Posttraumatic Osteoarthritis

Anterior Cruciate Ligament Transection and Synovial Fluid Lavage in a Rodent Model to Study Joint Inflammation and Posttraumatic Osteoarthritis

Published on: September 2, 2025

Related Concept Videos

Functional Classification of Joints

Functional Classification of Joints

Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An...

Classification of Bones

Classification of Bones

The bones of the human skeletal system are of varied shapes, sizes, and functions. They can be classified based on their shape and function into four major classes: long bones, short bones, flat bones, and irregular bones. Some classifications include a fifth type, the sesamoid bones, as a separate class, whereas others categorize them under short bones.
Long and Short Bones
The appendicular skeleton, particularly the upper and lower limbs, is primarily made of long and short bones. The...

Structural Classification of Joints

Structural Classification of Joints

Joints, also known as articulations, are classified based on their structural characteristics, i.e., based on whether the articulating surfaces of the adjacent bones are directly connected by fibrous connective tissue or cartilage, or whether the articulating surfaces contact each other within a fluid-filled joint cavity. These differences serve to divide the joints of the body into three structural classifications.
A fibrous joint is where the adjacent bones are united by fibrous connective...

Bones of the Upper Limb: Radius

Bones of the Upper Limb: Radius

The radius is longer of the two bones that make up the human antebrachium or forearm. At the proximal end, the radius articulates with the capitulum of the humerus and the radial notch of the ulna to form the elbow joint. At the distal end, the radius articulates with the ulna via the ulnar notch, forming the distal radioulnar joint. Distally, the radius also attaches to the carpal wrist bones (scaphoid and lunate) to form the radiocarpal joint.
The radius has a nail-shaped head, and a...

Introduction to Joints

Introduction to Joints

The adult human body usually has 206 bones, and except for the hyoid bone in the neck, each bone is connected to at least one other bone. Joints are the location where bones come together. Many joints allow for movement between the bones. At these joints, the articulating surfaces of the adjacent bones can move smoothly against each other. However, the bones of other joints may be joined by connective tissue or cartilage. These joints are designed for stability and provide little or no...

Articulations of the Vertebral Column

Articulations of the Vertebral Column

In addition to being held together by the intervertebral discs, adjacent vertebrae also articulate with each other at synovial joints formed between the superior and inferior articular processes called zygapophysial joints (facet joints). These are plane joints that provide for only limited motions between the vertebrae. The orientation of the articular processes at these joints varies in different regions of the vertebral column and serves to determine the types of motions available in each...

Articles linked to this work by shared authors, journal, and citation graph.

The Diagnosis, Treatment, and Aftercare of Ankle Fractures.

Deutsches Arzteblatt international·2026

Quantification of mobilization and pain level in fragility fracture of the pelvis.

Injury·2026

[Rare tendon injuries of the foot and ankle : Tibialis posterior-Tibialis anterior-Peroneus longus and brevis].

Unfallchirurgie (Heidelberg, Germany)·2026

Opportunistic bone density measurement on fragility fracture of the pelvis II and III: Hounsfield units might help to reveal dormant fractures in native computed tomography scan.

European journal of trauma and emergency surgery : official publication of the European Trauma Society·2026

Foot Dimension Assessment: Reliability and Agreement of Manual, Pedobarographic, and Handheld 3D Scanning Methods.

Journal of clinical medicine·2026

Early detection of osteoporosis in adult children of patients with proximal femur fractures: a real-world screening study.

BMC musculoskeletal disorders·2025

See all related articles