Kinematics of transition during human accelerated sprinting

Ryu Nagahara1, Takeo Matsubayashi2, Akifumi Matsuo3

  • 1Faculty of Health and Sport Sciences, University of Tsukuba, Ibaraki 305-8574, Japan nagahara.r@gmail.com.

Biology Open
|July 6, 2014
PubMed

Related Concept Videos

Kinematic Equations - I01:26

Kinematic Equations - I

When an object moves with constant acceleration, the velocity of the object changes at a constant rate throughout the motion. The kinematic equations of motions are derived for such cases where the acceleration of the object is constant. The first kinematic equation gives an insight into the relationship between velocity, acceleration, and time. We can see, for example:
13.2K
Instantaneous Acceleration01:16

Instantaneous Acceleration

Acceleration is in the direction of the change in velocity, but it is not always in the direction of motion. When an object slows down, its acceleration is opposite to the direction of its motion. Although commonly referred to as deceleration, this causes confusion in our analysis as deceleration is not a vector, and does not point to a specific direction with respect to a coordinate system. Therefore, the term deceleration is not used. For example, when a subway train slows down, it...
20.3K
Kinematic Equations - II01:17

Kinematic Equations - II

The second kinematic equation expresses the final position of an object in terms of its initial position, the distance traveled with the initial constant velocity, and the distance traveled due to a change in velocity. Similar to the first kinematic equation, this equation is also only valid when the acceleration is constant throughout the motion of an object.
Suppose a car merges into freeway traffic on a 200 m long ramp. If its initial velocity is 10 m/s and it accelerates at 2 m/s2, then the...
12.0K
Relative Motion Analysis - Acceleration01:10

Relative Motion Analysis - Acceleration

A slider-crank mechanism converts rotational motion from the crank into linear motion of the slider or vice versa. This mechanism consists of three main parts: the crank, the connecting rod, and the slider. The movement of the slider-crank is an example of general plane motion as the fluctuating angle between the crank and the connecting rod. Consider a segment AB where point A is at the end of the slider and point B is on the diametrically opposite end to point A, on a crack. The variance in...
1.1K
Velocity and Position by Graphical Method01:34

Velocity and Position by Graphical Method

Velocity and position can be calculated from the known function of acceleration as a function of time. The total area under the acceleration-time graph and the velocity-time graph gives the change in velocity and position, respectively. In the case of an airplane, its acceleration is tracked using the inertial navigation system. The pilot provides the input of the airplane's initial position and velocity before takeoff. The inertial navigation system then uses the acceleration data to...
9.3K
Kinematic Equations - III01:18

Kinematic Equations - III

The first two kinematic equations have time as a variable, but the third kinematic equation is independent of time. This equation expresses final velocity as a function of the acceleration and distance over which it acts. The fourth kinematic equation does not have an acceleration term and provides the final position of the object at time t in terms of the initial and final velocities. This equation is useful when the value of the constant acceleration is unknown.
Using the kinematic equations,...
9.9K