Mode selection for corrosion detection in pipes and vessels via guided wave tomography

Guided wave tomography offers a method to accurately quantify wall thickness losses in pipes and vessels caused by corrosion, using ultrasonic waves transmitted over distances of approximately 1 to 2 m, and measured by an array of transducers. These measurements are then used to reconstruct a map of wall thickness throughout the inspected region. To achieve accurate estimations of remnant wall thickness, it is vital that a suitable Lamb mode is chosen. This paper presents a detailed evaluation of the two most suitable modes, S0 and A0, to compare their performance using both numerical and experimental data. The sensitivity of A0 to thickness variations was shown to be superior to S0; however, the attenuation from A0 when a liquid loading was present was much higher than S0. A0 was less sensitive to the presence of coatings on the surface than was S0. Finally, it was shown that both modes could achieve a similar level of resolution in the plane of the plate surface.