Body segment inertial parameters and low back load in individuals with central adiposity

There is a paucity of information regarding the impact of central adiposity on the inertial characteristics of body segments. Deriving low back loads during lifting requires accurate estimate of inertial parameters. The purpose was to determine the body segment inertial parameters of people with central adiposity using a photogrammetric technique, and then to evaluate the impact on lumbar spine loading. Five participants with central adiposity (waist:hip ratio>0.9, waist circumference>102 cm) were compared to a normal BMI group. A 3D wireframe model of the surface topography was constructed, partitioned into 8 body segments and then body segment inertial parameters were calculated using volumetric integration assuming uniform segment densities for the segments. Central adiposity dependent increases in body segment parameters ranged from 12 to 400%, varying across segments (greatest for trunk) and parameters. The increase in mass distribution to the trunk was accompanied by an anterior and inferior shift of the centre of mass. A proximal shift in centre of mass was detected for the extremities, along with a reduction in mass distribution to the lower extremity. L5/S1 torques (392 vs 263 Nm) and compressive forces (5918 vs 3986 N) were substantially elevated in comparison to the normal BMI group, as well as in comparison to torques and forces predicted using published BSIP equations. Central adiposity resulted in substantial but non-uniform increases in inertial parameters resulting in task specific increases in torque and compressive loads arising from different inertial and physical components.