Effect of cleansing methods on saliva-contaminated zirconia--an evaluation of resin bond durability

The aims of this study were to investigate 1) the influence of cleansing methods after saliva contamination and 2) aging conditions (thermocycling and water storage) on zirconia shear bond strength (SBS) with a resin cement. One hundred and eighty zirconia specimens were sandblasted with 50 μm aluminum oxide particles, immersed in saliva for one minute (with the exception of the control group, [C]), and divided into groups according to the cleansing method, as follows: water rinse (W); 37% phosphoric acid gel (PA); cleaning paste (ie, Ivoclean®) containing mainly zirconium oxide (IC); and 70% isopropanol (AL). Scanning electron microscopy was done to qualitatively evaluate the zirconia surface after each cleansing method. For the SBS test, resin cement buttons were bonded to the specimens using a dedicated jig. SBS was evaluated according to standard protocols after 24 hours, 5000 thermal cycles (TC), or 150 days of water storage. Statistical analysis was performed using two-way analysis of variance and Tukey test (p<0.05). Data showed a significant effect for the 150 days of water storage, TC, and 24 hours of water storage (150 days < TC < 24 hours). Group comparisons showed that PA < AL and W < IC and C. SBS ranged from 10.4 to 21.9 MPa (24 hours), from 6.4 to 14.8 MPa (TC), and from 2.9 to 7.0 MPa (150 days). Failure analysis revealed a greater percentage of mixed failures for the majority of the specimens and a smaller percentage of adhesive failures at the ceramic-resin cement interface. Our findings suggest that Ivoclean® was able to maintain adequate SBS values after TC and 150 days of storage, comparable to the uncontaminated zirconia.