Crash and traffic violation rates before and after licensure for novice California drivers subject to different

Eric A Chapman1, Scott V Masten1, Kelly K Browning2

  • 1California Department of Motor Vehicles, Research and Development Branch, 2570 24th Street, MS H-126, Sacramento, CA 95818-2606, USA.

Abstract

Related Concept Videos

Hypothesis Test for Test of Independence01:16

Hypothesis Test for Test of Independence

The test of independence is a chi-square-based test used to determine whether two variables or factors are independent or dependent. This hypothesis test is used to examine the independence of the variables. One can construct two qualitative survey questions or experiments based on the variables in a contingency table. The goal is to see if the two variables are unrelated (independent) or related (dependent). The null and alternative hypotheses for this test are:
H0: The two variables (factors)...
6.3K
Application of Rates of Change01:18

Application of Rates of Change

The movement of a car along a highway can be examined through key principles of calculus and kinematics. As the car travels, its position varies over time and can be represented mathematically as a function of time. Analyzing the rate of these changes enables the measurement of velocity and acceleration, fundamental aspects of motion analysis.Velocity describes how position changes over time. The average velocity during a specific time interval is calculated by dividing the change in position...
696
Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
428
Sight Distance in a Vertical Curve01:29

Sight Distance in a Vertical Curve

Sight distance on vertical curves is critical in roadway design. It ensures drivers can see far enough ahead to identify and respond to hazards effectively. This directly impacts safety, driver comfort, and the overall efficiency of the transportation network.Vertical curves are classified into crest and sag curves based on their geometry. For crest curves, sight distance is determined by the line of sight between a driver's eye and a small object on the road's surface. Design parameters for...
554
Introduction to Test of Independence01:21

Introduction to Test of Independence

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
2.1K
The Anchoring-and-Adjustment Heuristic01:25

The Anchoring-and-Adjustment Heuristic

In order to make good decisions, we use our knowledge and our reasoning. Often, this knowledge and reasoning is sound and solid. However, sometimes, we are swayed by biases or by others manipulating a situation. For example, let’s say you and three friends wanted to rent a house and had a combined target budget of $1,600. The realtor shows you only very run-down houses for $1,600 and then shows you a very nice house for $2,000. Might you ask each person to pay more in rent to get the...
6.7K