Related Experiment Video
Updated: Apr 25, 2026

Fabrication and Testing of Microfluidic Optomechanical Oscillators
Published on: May 29, 2014
A low-phase-noise Ka-band push-push voltage-controlled oscillator using CMOS/glass-integrated passive device
Abstract:
In this paper, a Ka-band CMOS push-push voltage- controlled oscillator (VCO) integrated into a glass-integrated passive device (GIPD) process is presented. The transformer, λ/4 transmission line, and inductors of the VCO are realized in the GIPD process, achieving superior performances, and therefore improve the phase noise of the VCO. Moreover, the transformer-based VCO is a differential Hartley topology to further reduce the phase noise and chip area. Operating at 1.8 V supply voltage, the VCO core consumes merely 3.8 mW of dc power. The measured phase noise is -109.18 dBc/Hz at 1 MHz offset from the 30.84 GHz oscillation frequency. The push-push VCO also demonstrates a 24.5 dB fundamental rejection, and exhibits an 8.4% tuning range. Compared with recently published CMOS-based VCOs, it is observed that the proposed VCO exhibits excellent performance under low power consumption.
Related Concept Videos
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
MOSFET Amplifiers
MOSFET: Depletion Mode
The primary characteristic of depletion-mode MOSFETs is their ability to conduct current between the drain and source terminals without gate bias. This inherent conductivity...
MOSFET
In an n-MOSFET, the structure includes n-type source and drain...
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
Small-Signal Analysis of MOSFET Amplifiers

