Induced groundwater flux by increases in the aquifer's total stress

Ching-Min Chang1, Hund-Der Yeh

  • 1Institute of Environmental Engineering, National Chiao Tung University, Hsinchu, Taiwan.

Ground Water
|September 3, 2014
PubMed

Related Concept Videos

Responses to Drought and Flooding02:41

Responses to Drought and Flooding

Water plays a significant role in the life cycle of plants. However, insufficient or excess of water can be detrimental and pose a serious threat to plants.
10.2K
Responses to Salt Stress02:02

Responses to Salt Stress

Salt stress—which can be triggered by high salt concentrations in a plant’s environment—can significantly affect plant growth and crop production by influencing photosynthesis and the absorption of water and nutrients.
12.2K
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
830
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
809
Indefinite Integrals01:25

Indefinite Integrals

The water inflow rate into a storage tank is not constant but increases over time. Initially, the pump delivers water at a rate of 5 L/min. However, the inflow rate increases by 2 L/min for each additional minute due to rising pressure or system adjustments. This scenario can be described mathematically by a linear function:It is necessary to integrate the inflow rate function to measure the total volume of water added to the tank over time. The total water volume V(t) is obtained by performing...
229
Applications of Integration to Find Hydrostatic Pressure01:30

Applications of Integration to Find Hydrostatic Pressure

Hydrostatic force is a fluid's total force at rest on a surface. For a horizontal surface submerged at a fixed depth, the pressure is constant and calculated as the product of fluid density, gravitational acceleration, and depth. In the case of a vertical dam wall submerged in water, this force is not evenly distributed due to the increasing pressure with depth. This variation arises from the cumulative weight of the water above each point. Integration is used to account for the continuous...
347