Related Experiment Video
Updated: Apr 23, 2026

06:48
A Multimodal Wide-Field Fourier-Transform Raman Microscope
Published on: December 30, 2025
853
Imaging molecular crystal polymorphs and their polycrystalline microstructures in situ by ultralow-frequency Raman
Chun-Fu Chang1, Hajime Okajima, Hiro-o Hamaguchi
1Department of Applied Chemistry and Institute of Molecular Science, National Chiao Tung University, Hsinchu 30010, Taiwan. shigeto@mail.nctu.edu.tw.
Abstract:
Ultralow-frequency Raman spectroscopy that can measure vibrational bands at as low as ±10 cm(-1) has enabled facile in situ imaging of polycrystalline microstructures such as grains and grain boundaries with high polymorph specificity. We demonstrate this method by investigating microcrystals of two distinct polymorphs of 1,1'-binaphthyl using a microscope.
More Related Videos
Related Concept Videos
Raman Spectroscopy: Overview
2.5K
The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
2.5K
Raman Spectroscopy Instrumentation: Overview
1.8K
A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
1.8K

