Related Experiment Video
Updated: Apr 23, 2026

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Microbiological comparison of hand-drying methods: the potential for contamination of the environment, user, and
E L Best1, P Parnell1, M H Wilcox2
1Microbiology Department, Old Medical School, Leeds General Infirmary, Leeds Teaching Hospitals NHS Trust, Leeds, UK.
Background:
The efficiency of hand drying is important in preventing pathogen spread, but knowledge surrounding which drying methods contribute least towards contamination of the environment and users is limited.
Aim:
To compare the propensity of three common hand-drying methods (jet air, warm air dryers, and paper towels) to contaminate the environment, users, and bystanders.
Methods:
Hands were coated in lactobacilli to simulate poorly washed, contaminated hands, and dried. The investigation comprised 120 air-sampling tests (60 tests and 60 controls), divided into close and 1m proximity from the drying process. Separate tests used hands coated in paint to visualize droplet dispersal.
Findings:
Air bacterial counts in close proximity to hand drying were 4.5-fold higher for the jet air dryer (70.7 cfu) compared with the warm air dryer (15.7 cfu) (P=0.001), and 27-fold higher compared with use of paper towels (2.6 cfu) (P<0.001). Airborne counts were also significantly different during use of towel drying versus warm air dryer (P=0.001). A similar pattern was seen for bacterial counts at 1m away. Visualization experiments demonstrated that the jet air dryer caused the most droplet dispersal.
Conclusion:
Jet air and warm air dryers result in increased bacterial aerosolization when drying hands. These results suggest that air dryers may be unsuitable for use in healthcare settings, as they may facilitate microbial cross-contamination via airborne dissemination to the environment or bathroom visitors.
Related Concept Videos
Handwashing III: During the Procedure and Post-Procedure Steps
Handwashing I: Introduction and Types of Equipment
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated....
Hand hygiene
Hand washing...
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Microbial Growth Measurement: Direct Methods
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...

