The Comparison Question Test versus the Concealed Information Test? That was the question in Japan: a comment on

Tokihiro Ogawa1, Izumi Matsuda1, Michiko Tsuneoka1

  • 1National Research Institute of Police Science, 6-3-1 Kashiwanoha, Kashiwa, Chiba 277-0882, Japan.

Related Concept Videos

Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
Significance Testing: Overview01:04

Significance Testing: Overview

Significance testing is a set of statistical methods used to test whether a claim about a parameter is valid. In analytical chemistry, significance testing is used primarily to determine whether the difference between two values comes from determinate or random errors. The effect of a particular change in the measurement protocol, analyst, or sample itself can cause a deviation from the expected result. In the case of a suspected deviation/outlier, we need to be able to confirm mathematically...
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Comparison Tests01:28

Comparison Tests

An infinite series composed of positive terms may either approach a finite value or increase without bound. Determining which outcome occurs is a central task in calculus, and comparison tests provide structured methods for making this determination. Rather than evaluating a series directly, these tests relate it to another series whose behavior is already known, allowing conclusions to be drawn through logical comparison.The direct comparison test applies to series with positive terms. If each...