Related Experiment Video
Updated: Apr 23, 2026
Measurement of Dynamic Scapular Kinematics Using an Acromion Marker Cluster to Minimize Skin Movement Artifact
Published on: February 10, 2015
Assessment of the function and resistance of sternoclavicular ligaments: A biomechanical study in cadavers
J H Negri1, E A Malavolta1, J H Assunção1
1Department of Orthopedics and Traumatology, School of Medicine, University of São Paulo (USP), São Paulo, Brazil.
Background:
Few biomechanical studies have assessed the resistance of the ligamentous structures of the sternoclavicular joint, and none have reproduced the physiological movements of the joint. Determining the structures that are injured in sternoclavicular dislocations is important for the surgical planning of acute or chronic ligament reconstruction.
Methods:
Forty-eight joints from 24 human cadavers were studied, and they were divided into 4 groups of 12 joints each (retraction, protraction, depression and elevation). Biomechanical testing assessed primary and secondary failures. The mechanical resistance parameters between movements that occurred on the same plane (depression versus elevation, protraction versus retraction) were compared.
Results:
The posterior sternoclavicular ligament was the most injured structure during the protraction test, but it was not injured during retraction. The anterior sternoclavicular ligament was the most affected structure during retraction and depression. The costoclavicular ligament was the most affected structure during elevation. Joint resistance was significantly greater during protraction movements when compared to retraction (P<0.05).
Conclusion:
The anterior sternoclavicular ligament was the most affected structure during retraction and depression movements. During protraction, lesions of the posterior sternoclavicular ligament were most frequent during elevation, and the costoclavicular ligament was the most frequently injured ligament. The resistance of the sternoclavicular joint was significantly greater during protraction movement when compared to retraction.
Level Of Evidence:
IV, basic science, biomechanics, cadaver model.
Related Concept Videos
01:17The Thoracic Cage: Sternum
The sternum is the elongated bony structure on the anterior side of the thoracic cage. It consists of three parts: the manubrium, the body, and the xiphoid...
01:27Assessment of the Cardiovascular System III: Palpation
Jugular Venous Pressure (JVP) Measurement
Position the patient at a thirty- to forty-five-degree angle or in a semi-fowler's position. Look for the highest point of pulsation in the internal jugular vein and measure the vertical distance to the angle of Loius or sternal angle. A normal JVP is 3-4 cm above...
01:17Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...
01:23Muscles of the Shoulder
Anterior Thoracic Muscles
The anterior thoracic muscles include the serratus anterior, subclavius, and...
01:30Assessment of Airway, Skin Color, and Use of Accessory Muscles
Introduction
The initial evaluation of a patient's respiratory system...
01:23Assessment of the Abdomen III: Palpation