Poly(amide-imide)/silica supported PEI hollow fiber sorbents for postcombustion CO(2) capture by RTSA

Amine-loaded poly(amide-imide) (PAI)/silica hollow fiber sorbents are created and used in a rapid temperature swing adsorption (RTSA) system for CO2 capture under simulated postcombustion flue gas conditions. Poly(ethylenimine) (PEI) is infused into the PAI/mesoporous silica hollow fiber sorbents during fiber solvent exchange steps after fiber spinning. A lumen-side barrier layer is also successfully formed on the bore side of PAI/silica hollow fiber sorbents by using a mixture of Neoprene with cross-linking agents in a post-treatment process. The amine loaded fibers are tested in shell-and-tube modules by exposure on the shell side at 1 atm and 35 °C to simulated flue gas with an inert tracer (14 mol % CO2, 72 mol % N2, and 14 mol % He, at 100% relative humidity (RH)). The fibers show a breakthrough CO2 capacity of 0.85 mmol/g-fiber and a pseudoequilibrium CO2 uptake of 1.19 mmol/g-fiber. When tested in the temperature range of 35-75 °C, the PAI/silica/PEI fiber sorbents show a maximum CO2 capacity at 65 °C, owing to a trade-off between thermodynamic and kinetic factors. To overcome mass transfer limitations in rigidified PEI infused in the silica, an alternate PEI infusion method using a glycerol/PEI/methanol mixture is developed, and the CO2 sorption performance is improved significantly, effectively doubling the functional sorption capacity. Specifically, the glycerol-plasticized sorbents are found to have a breakthrough and equilibrium CO2 capacity of 1.3 and 2.0 mmol/g of dry fiber sorbent at 35 °C, respectively. Thus, this work demonstrates two PAI-based sorbents that are optimized for different sorption conditions with the PAI/silica/PEI sorbents operating effectively at 65 °C and the PAI/silica/PEI-glycerol sorbents operating well at 35 °C with significantly improved sorption capacity.