Double-wall TiO2 nanotube arrays: enhanced photocatalytic activity and in situ TEM observations at high temperature

By decreasing the water content in an NH4F and glycerol-water electrolyte, the transition from single-wall to double-wall TiO2 nanotube arrays was successfully achieved using an anodization method. The double-wall TiO2 nanotube structures exhibited better photocatalytic activity than the typical single-wall structures. After modification with platinum nanoparticles, the photocatalytic activity of both the single- and double-wall TiO2 nanotubes was improved further. In situ observations at the annealing temperature of the TiO2 nanotubes were performed using a transmission electron microscopy (TEM) system. A slower structural failure of the nanotubes was obtained with the introduction of oxygen gas into the TEM column compared with the structural changes observed under high-vacuum conditions without the introduction of oxygen gas. These behaviors suggest that oxygen injection is an important factor in stabilizing the TiO2 nanotubes during the in situ TEM annealing process. The high-magnification TEM images of the double-wall TiO2 nanotubes revealed that the sintering of the inner wall can draw a clear distinction between the inner and outer walls.