Related Experiment Video

Updated: Apr 20, 2026

Microtensiometer for Confocal Microscopy Visualization of Dynamic Interfaces
08:05

Microtensiometer for Confocal Microscopy Visualization of Dynamic Interfaces

Published on: September 9, 2022

3.1K

Surface dilational moduli of polymer and blended polymer monolayers spread at air-water interfaces

Takako Morioka1, Masami Kawaguchi1

  • 1Division of Chemistry for Materials, Graduate School of Engineering, Mie University, 1577 Kurimamachiya, Tsu, Mie 514-8507, Japan.

Advances in Colloid and Interface Science
|December 3, 2014
PubMed

Keywords:
Lissajous orbitsOscillating barrier methodPolymer blended monolayerPolymer monolayersSurface dilational moduli

More Related Videos

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface07:06

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface

Published on: April 7, 2017

6.5K
Thin Film Composite Silicon Elastomers for Cell Culture and Skin Applications: Manufacturing and Characterization08:02

Thin Film Composite Silicon Elastomers for Cell Culture and Skin Applications: Manufacturing and Characterization

Published on: July 3, 2018

11.3K

Related Concept Videos

Bulk Modulus01:21

Bulk Modulus

The bulk modulus is a scientific term used to describe a material's resistance to uniform compression. It is the proportionality constant that links a change in pressure to the resulting relative volume change.
969
Molecular Weight of Step-Growth Polymers01:08

Molecular Weight of Step-Growth Polymers

Step growth polymerization involves bi or multifunctional monomers. Bifunctional monomers react to form linear step growth polymers, whereas multifunctional monomers react to form non-linear or branched polymers.
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
3.1K
Polymers: Molecular Weight Distribution01:10

Polymers: Molecular Weight Distribution

For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
5.3K
Polymer Classification: Architecture01:14

Polymer Classification: Architecture

Polymers are classified as linear or branched on the basis of their chain architecture. The polymer chains in linear polymers have a long chain-like structure with minimal to no branching at all. Even if a polymer features large substituent groups on the monomer, which appear as branches to the skeleton, it is not considered a branched polymer. A branched polymer contains secondary polymer chains that arise from the main polymer chain. The branching occurs when the polymer growth shifts from...
4.2K