Coefficient of performance under maximum χ criterion in a two-level atomic system as a refrigerator

Refrigerators or heat pumps are heat engines operating in a reverse direction. For a refrigerator, the focus is on removing heat from a specific area, whereas, for a heat pump, the focus is on dumping heat into one particular area. A refrigerator (or heat pump) absorbs heat Qc from the cold reservoir at Kelvin temperature Tc and discards heat Qh to the hot reservoir at Kelvin temperature Th, while work W is done on the engine’s working substance.
A household refrigerator removes heat from...

Activity is the measure of the effective concentration of the species in solution. It can be expressed as the product of the molar concentration of the species and its activity coefficient. The activity coefficient is a dimensionless quantity and depends on the total ionic strength of the solution.
The activity coefficient is a measure of the deviation from ideal behavior. When the ionic strength of the solution is minimal, the activity coefficient of an ionic species is close to unity, making...

The Carnot engine works between two heat reservoirs of fixed temperatures. The Carnot cycle begs the following question: Is it possible to devise a heat engine that is more efficient than a Carnot engine between two fixed temperatures? The answer lies in designing a Carnot refrigerator.
Since the individual steps in a Carnot cycle can be reversed, the entire cycle is, thus, reversible. If a Carnot cycle is reversed, it becomes a Carnot refrigerator. It extracts heat Qc from a cold reservoir at...

The number of independent ways a gas molecule can move along straight line, rotate, and vibrate is called its degrees of freedom. Supposing d represents the number of degrees of freedom of an ideal gas, the molar heat capacity at constant volume of an ideal gas in terms of d is

For a system that undergoes a thermodynamic process at a constant volume condition, the heat absorbed is used only to increase the system's internal energy and not for doing any kind of work. While for a system undergoing a thermodynamic process under a constant pressure condition, the amount of heat absorbed is used not only for increasing the internal energy (as a function of temperature) but also for doing some work. The molar heat capacity is the amount of heat required to increase the...

Near absolute zero temperatures, in the presence of a magnetic field, the majority of nuclei prefer the lower energy spin-up state to the higher energy spin-down state. As temperatures increase, the energy from thermal collisions distributes the spins more equally between the two states. The Boltzmann distribution equation gives the ratio of the number of spins predicted in the spin −½ (N−) and spin +½ (N+) states.