Accounting for the Material Stock of Nations

Journal of Industrial Ecology
|December 16, 2014
PubMed

Related Concept Videos

Steel Manufacturing01:26

Steel Manufacturing

Steel manufacturing is a multi-stage process that begins by smelting iron ore into cast iron in a blast furnace. This initial stage involves layering iron ore with coke, a type of fuel, and crushed limestone within the furnace. The coke is ignited with a high volume of air, leading to the creation of carbon monoxide, which acts to reduce the iron ore to pure iron.
During this smelting process, limestone plays a crucial role by forming slag. Slag captures impurities within the molten iron, such...
1.8K
Yield Criteria for Ductile Materials under Plane Stress01:25

Yield Criteria for Ductile Materials under Plane Stress

In designing structural elements and machine parts using ductile materials, it is crucial to ensure that these components withstand applied stresses without yielding. Yielding is initially determined through a tensile test, which evaluates the material's response to uniaxial stress. However, tensile stress is insufficient when components face biaxial or plane stress conditions This condition requires advanced criteria to predict failure.
The Maximum Shearing Stress Criterion, also known as...
789
Unsymmetric Loading of Thin-Walled Members01:23

Unsymmetric Loading of Thin-Walled Members

Thin-walled members with non-symmetrical cross-sections are vital to engineering structures, offering material efficiency and structural integrity. However, unsymmetrical loading on these members leads to complex stress distributions, resulting in simultaneous bending and twisting can cause deformation or structural failure. The interaction between bending and twisting requires detailed analysis to ensure structural resilience.
The concept of the shear center is crucial in countering the...
501
Base Quantities and Derived Quantities01:14

Base Quantities and Derived Quantities

In any system of units, the units for some physical quantities must be specified through a measurement process. These measurements are the base quantities of the system, and their units are the base units of the system. The algebraic combinations of the base values can then be used to express all other physical quantities. Each of these physical quantities is then referred to as a derived quantity, with each unit being referred to as a derived unit.
The International Organization for...
27.9K
States of Matter01:20

States of Matter

Solids, liquids, and gases are the three states of matter commonly found on Earth. A solid is rigid and possesses a definite shape. A liquid flows and takes the shape of its container, except it forms a flat or slightly curved upper surface when acted upon by gravity. Both liquid and solid samples have volumes nearly independent of pressure. A gas takes both the shape and volume of its container.
Scientists have discovered a fourth state of matter, plasma, that occurs naturally in the interiors...
3.3K
The Colonization of Land02:22

The Colonization of Land

Changes in the environment of the early Earth drove the evolution of organisms. As prokaryotic organisms in the oceans began to photosynthesize, they produced oxygen. Eventually, oxygen saturated the oceans and entered the air, resulting in an increase in atmospheric oxygen concentration, known as the oxygen revolution approximately 2.3 billion years ago. Therefore, organisms that could use oxygen for cellular respiration had an advantage. More than 1.5 years ago, eukaryotic cells and...
38.9K