Related Experiment Video
Updated: Apr 19, 2026
Accuracy in Dental Medicine, A New Way to Measure Trueness and Precision
Published on: April 29, 2014
Comparison of an analog and digital quantitative and qualitative analysis for the fit of dental copings
Katharina Kuhn1, Silke Ostertag2, Michael Ostertag2
1Center of Dentistry, Department of Prosthetic Dentistry, Ulm University, 89081 Ulm, Germany.
Background:
Precision in fit is crucial for dental crowns and bridges. Most analyses of fit are based on analog 2D techniques. Aim of this in-vitro study was to compare an analog and a digital quantitative and qualitative analysis for the fit of CAD/CAM fabricated dental copings.
Methods:
A prepared steel canine served as master die. CAD surface models, varying in data density, were purposely enlarged in height (Ez), circumference (Exy) and both of these aspects at once (Exyz). Two titanium copings for each variation were produced. The silicone-replica-technique was applied to analyze the fit by means of a 2D analog light microscope measurement (LMM) and a 3D computer-assisted measurement using an optical digitizing system (ODKM97), respectively.
Results:
In most cases, restorations based on the low data density showed a better fit than those based on high data density. Original size low density data showed the lowest marginal and axial values in the quantitative 2D analyses (LMM and ODKM97). The 3D measurements (ODKM97) revealed best fit of the low density original size specimens, whereas the Ez specimens showed the highest values. Noticeable variations in fit were detected marginally and axially depending on the specific measurement point (mesial, distal, oral, or buccal) for both measurement systems.
Discussion:
The analog 2D replica technique revealed a loss of information due to the necessary cutting process. By contrast, the digital computer-based method provided 3D quantitative and qualitative results without data loss over the complete surface.
