Private well water in Colorado: collaboration, data use, and public health outreach

Eric M Brown1, Mike Van Dyke, Stephanie Kuhn

  • 1Colorado Environmental Public Health Tracking (Mr Brown and Ms Kuhn), Environmental Epidemiology, Occupational Health and Toxicology (Dr Van Dyke), and Disease Control and Environmental Epidemiology Division (Ms Mitchell), Colorado Department of Public Health and Environment, Denver; and Tri-County Health Department, Greenwood Village, Colorado (Ms Dalton).

Related Concept Videos

Water and Mineral Acquisition02:34

Water and Mineral Acquisition

Specialized tissues in plant roots have evolved to capture water, minerals, and some ions from the soil. Roots exhibit a variety of branching patterns that facilitate this process. The outermost root cells have specialized structures called root hairs that increase the root surface, thus increasing soil contact. Water can passively cross into roots, as the concentration of water in the soil is higher than that of the root tissue. Minerals, in contrast, are actively transported into root cells.
36.8K
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
722
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
587
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
58.5K
Analysis of Population Pharmacokinetic Data01:12

Analysis of Population Pharmacokinetic Data

Analysis of population pharmacokinetic data involves studying the behavior of drugs within diverse populations to understand their pharmacokinetic parameters. Traditional pharmacokinetic methods typically involve collecting samples from a few individuals and estimating these parameters. While these methods are commonly used, they have limitations in capturing the variability in drug response among individuals or heterogeneous populations. Population pharmacokinetics is employed to address these...
955
Water: A Bronsted-Lowry Acid and Base02:30

Water: A Bronsted-Lowry Acid and Base

The reaction between a Brønsted-Lowry acid and water is called acid ionization. For example, when hydrogen fluoride dissolves in water and ionizes, protons are transferred from hydrogen fluoride molecules to water molecules, yielding hydronium ions and fluoride ions:
62.3K