Related Experiment Video

Updated: Apr 17, 2026

Preparation of 6-aminocyclohepta-2,4-dien-1-one Derivatives via Tricarbonyltroponeiron
07:56

Preparation of 6-aminocyclohepta-2,4-dien-1-one Derivatives via Tricarbonyltroponeiron

Published on: August 12, 2019

8.5K

Synthesis, spectroscopic characterization, biological screenings, DNA binding study and POM analyses of transition

Noor Uddin1, Muhammad Sirajuddin2, Nizam Uddin1

  • 1Department of Chemistry Quaid-i-Azam University, 45320 Islamabad, Pakistan.

Spectrochimica Acta. Part A, Molecular and Biomolecular Spectroscopy
|February 4, 2015
PubMed

Keywords:
Antifungal activityAntileishmanial activityDNA-interactionMetal carboxylatePOM analysis

More Related Videos

Synthesis and Performance Characterizations of Transition Metal Single Atom Catalyst for Electrochemical CO2 Reduction10:57

Synthesis and Performance Characterizations of Transition Metal Single Atom Catalyst for Electrochemical CO2 Reduction

Published on: April 10, 2018

19.4K
Qualitative Identification of Carboxylic Acids, Boronic Acids, and Amines Using Cruciform Fluorophores09:46

Qualitative Identification of Carboxylic Acids, Boronic Acids, and Amines Using Cruciform Fluorophores

Published on: August 19, 2013

16.1K

Related Concept Videos

Properties of Organometallic Compounds01:23

Properties of Organometallic Compounds

Organometallic compounds are compounds that contain a carbon–metal bond. Carbon belongs to an organyl group like alkyl, aryl, allyl, or benzyl groups. The metal can be from Group I or Group II of the periodic table, a transition metal, or a semimetal.
2.2K
IR and UV–Vis Spectroscopy of Carboxylic Acids01:28

IR and UV–Vis Spectroscopy of Carboxylic Acids

In IR spectroscopy of carboxylic acids, the C=O bond shows a characteristic band between 1710 and 1760 cm⁻¹, and the O–H bond exhibits a broad band between 2500 and 3300 cm⁻¹.
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency,...
6.3K
Spectroscopy of Carboxylic Acid Derivatives01:26

Spectroscopy of Carboxylic Acid Derivatives

Infrared spectroscopy is primarily used to determine the types of bonds and functional groups. In carboxylic acid derivatives, a typical carbonyl bond absorption is observed around 1650–1850 cm−1. For esters, the absorption is recorded at around 1740 cm−1, while acid halides show the absorption at about 1800 cm−1. Another acid derivative, the acid anhydrides, exhibit two carbonyl absorption around 1760 cm−1 and 1820 cm−1, arising from the symmetrical and...
3.3K
Oxidations of Aldehydes and Ketones to Carboxylic Acids01:15

Oxidations of Aldehydes and Ketones to Carboxylic Acids

Oxidation of aldehydes and ketones results in the formation of carboxylic acids. Aldehydes, bearing hydrogen next to the carbonyl group, are easily oxidized compared to ketones. This is because an aldehydic proton can easily be abstracted during oxidation.
Aldehydes readily undergo oxidation in strong oxidizing agents such as potassium permanganate and chromic acid. The oxidation can also be carried out using mild oxidizing agents such as silver oxide. In fact, aldehydes can be easily oxidized...
7.0K
NMR and Mass Spectroscopy of Carboxylic Acids01:30

NMR and Mass Spectroscopy of Carboxylic Acids

In ¹H NMR spectroscopy, acidic protons (–COOH) of carboxylic acids are highly deshielded and absorb far downfield, at around 9–12 ppm. The chemical shift value depends on the concentration and solvent used.
While α protons of carboxylic acids absorb at 2–2.5 ppm, β protons absorb further upfield.
Carboxylic acids are easily identified by dissolving them in deuterium oxide, which results in a rapid exchange of the acidic protons with deuterium. This leads to the...
5.7K
Properties of Transition Metals02:58

Properties of Transition Metals

Transition metals are defined as those elements that have partially filled d orbitals. As shown in Figure 1, the d-block elements in groups 3–12 are transition elements. The f-block elements, also called inner transition metals (the lanthanides and actinides), also meet this criterion because the d orbital is partially occupied before the f orbitals.
31.2K