Does food vendor density mediate the association between neighborhood deprivation and BMI?: a G-computation mediation

Y Tara Zhang1, Barbara A Laraia, Mahasin S Mujahid

  • 1From the aSchool of Public Health, Division of Epidemiology, bSchool of Public Health, Division of Community Health and Child Development, cDepartment of Environmental Science, Policy and Management, University of California, Berkeley, CA; dKaiser Permanente Division of Research, Oakland, CA; and eSchool of Medicine, University of California, San Francisco, CA.

Abstract

Related Concept Videos

Bulk Density of Aggregate01:22

Bulk Density of Aggregate

Bulk density refers to the mass of aggregate particles that would fill a unit volume. The concept of bulk density originates from the inability to pack aggregate particles in a manner that completely eliminates void spaces. Hence, the term bulk refers to the volume that encompasses both the aggregates and the voids. This measurement is crucial when aggregates are batched by volume and is used to convert quantities by mass to volume.
Most natural mineral aggregates, like sand and gravel,...
1.6K
Analysis of Population Pharmacokinetic Data01:12

Analysis of Population Pharmacokinetic Data

Analysis of population pharmacokinetic data involves studying the behavior of drugs within diverse populations to understand their pharmacokinetic parameters. Traditional pharmacokinetic methods typically involve collecting samples from a few individuals and estimating these parameters. While these methods are commonly used, they have limitations in capturing the variability in drug response among individuals or heterogeneous populations. Population pharmacokinetics is employed to address these...
953
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
9.2K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
21.1K
Measures of Central Tendency02:16

Measures of Central Tendency

The "center" of a data set is also a way of describing location. The two most widely used measures of the "center" of the data are the mean (average) and the median. The words "mean" and "average" are often used interchangeably. The substitution of one word for the other is common practice. The technical term is "arithmetic mean" and "average" is technically a center location. However, in practice among non-statisticians,...
23.7K
Relative Frequency Distribution00:55

Relative Frequency Distribution

A relative frequency distribution is the proportion or fraction of times a value occurs in a data set. To find the relative frequencies, one can divide each frequency by the total number of data points in the sample. It is very similar to a regular frequency distribution, except that instead of reporting how many data values fall in a class, a relative frequency distribution reports the fraction of data values that fall in a class. These fractions or proportions are called relative frequencies...
14.5K