Related Experiment Video
Updated: Apr 16, 2026

Anionic Polymerization of an Amphiphilic Copolymer for Preparation of Block Copolymer Micelles Stabilized by π-π Stacking Interactions
Published on: October 10, 2016
Oil-in-water emulsion lotion providing controlled release using 2-methacryloyloxyethyl phosphorylcholine n-butyl
Akiko Ishikawa1, Makiko Fujii1, Kumi Morimoto1
1Showa Pharmaceutical University, 3-3165, Higashi-Tamagawagakuen, Machida, Tokyo 194-8543, Japan.
Abstract:
Lotion is a useful vehicle for active ingredients used to treat skin disease because it can be applied to the scalp, can cover large areas of skin, and it is easy to spread due to low viscosity. An emulsion lotion (EL) containing 2-methacryloyloxyethyl phosphorylcholine n-butyl methacrylate copolymer (PMB) as an emulsifier that provides controlled-release was developed. Diphenhydramine (DPH) was used as a model drug. Formulation with 5% DPH, 5% soybean oil, and 4% PMB in water was emulsified using a high-pressure homogenizer. Polysorbate 80 (TO) was used instead of PMB for comparison. They were applied in vitro to Yucatan micropig intact or stripped skin at a practical dose (2 μL/cm(2)). For stripped skin, penetration of DPH from 4% PMB EL was slower than that from 1% TO EL; results for intact skin were similar. The same phenomenon was observed with application to rabbit skin in vivo. When 4% PMB EL dried on the skin, it made a thin film matrix incorporating the oil phase, which controlled the release of DPH. The release rate could be controlled by the ratio of oil phase to PMB. The EL with PMB shows promise as a vehicle for long-acting treatment of skin diseases.

