Related Experiment Video
Updated: Apr 15, 2026

Using Laser Scanning Microscopy to Determine Electromigration in Molybdenum Disilicide
Published on: May 23, 2025
Investigation of band-offsets at monolayer-multilayer MoS₂ junctions by scanning photocurrent microscopy
Sarah L Howell1, Deep Jariwala1, Chung-Chiang Wu1
1†Department of Materials Science and Engineering, ‡Department of Chemistry, §Department of Medicine, and ∥Materials Research Center, Northwestern University, Evanston, Illinois 60208, United States.
Abstract:
The thickness-dependent band structure of MoS2 implies that discontinuities in energy bands exist at the interface of monolayer (1L) and multilayer (ML) thin films. The characteristics of such heterojunctions are analyzed here using current versus voltage measurements, scanning photocurrent microscopy, and finite element simulations of charge carrier transport. Rectifying I-V curves are consistently observed between contacts on opposite sides of 1L/ML junctions, and a strong bias-dependent photocurrent is observed at the junction. Finite element device simulations with varying carrier concentrations and electron affinities show that a type II band alignment at single layer/multilayer junctions reproduces both the rectifying electrical characteristics and the photocurrent response under bias. However, the zero-bias junction photocurrent and its energy dependence are not explained by conventional photovoltaic and photothermoelectric mechanisms, indicating the contributions of hot carriers.
More Related Videos
09:49In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx
Published on: May 13, 2020
08:59Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM
Published on: January 23, 2013
Related Concept Videos
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...
Biasing of P-N Junction
In equilibrium, no external voltage is applied across the p-n junction. The depletion region is formed at the junction interface due to the diffusion of carriers, which leaves behind charged dopants, acceptors on the p-side, and donors on the n-side. These immobile charges create an electric field that prevents further diffusion of carriers. The related energy band...
Schottky Barrier Diode