Related Experiment Video

Updated: Apr 14, 2026

Synthesis and Microdiffraction at Extreme Pressures and Temperatures
07:26

Synthesis and Microdiffraction at Extreme Pressures and Temperatures

Published on: October 7, 2013

11.8K

Synergetic effect of temperature and pressure on energetic and structural characteristics of {ZIF-8 + water}

Ya Grosu1, G Renaudin, V Eroshenko

  • 1Clermont Université ENSCC, Institut de Chimie de Clermont-Ferrand, BP 10448, 63000 Clermont-Ferrand, France.

Nanoscale
|April 25, 2015
PubMed

More Related Videos

Molecular Spring Constant Analysis by Biomembrane Force Probe Spectroscopy08:10

Molecular Spring Constant Analysis by Biomembrane Force Probe Spectroscopy

Published on: November 20, 2021

3.5K
High-Pressure NMR Experiments for Detecting Protein Low-Lying Conformational States04:37

High-Pressure NMR Experiments for Detecting Protein Low-Lying Conformational States

Published on: June 29, 2021

3.3K

Related Concept Videos

Effects of Temperature on Free Energy02:11

Effects of Temperature on Free Energy

The spontaneity of a process depends upon the temperature of the system. Phase transitions, for example, will proceed spontaneously in one direction or the other depending upon the temperature of the substance in question. Likewise, some chemical reactions can also exhibit temperature-dependent spontaneities. To illustrate this concept, the equation relating free energy change to the enthalpy and entropy changes for the process is considered:
29.9K
Pressure Variation in a Fluid at Rest01:11

Pressure Variation in a Fluid at Rest

In a fluid at rest, the pressure at any point beneath the fluid surface depends solely on the depth, not on the container's shape or size. This principle, known as hydrostatic pressure, arises because, in stationary fluids, there is no acceleration, meaning the forces within the fluid balance out. Only vertical forces, caused by the weight of the fluid above, contribute to pressure changes with depth.
When measuring pressure at two different levels within the fluid, the difference in...
1.1K
Effect of Temperature Change on Reaction Rate02:28

Effect of Temperature Change on Reaction Rate

The Arrhenius equation,
5.7K
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
671
Pressure of Fluids01:14

Pressure of Fluids

There are many examples of pressure in fluids in everyday life, such as in relation to blood (high or low blood pressure) and in relation to weather (high- and low-pressure weather systems). A given force can have a significantly different effect, depending on the area over which the force is exerted. For instance, a force applied to an area of 1 mm2 has a pressure that is 100 times greater than the same force applied to an area of 1 cm2. That's why a sharp needle is able to poke through...
22.8K
Phase Diagram01:19

Phase Diagram

The phase of a given substance depends on the pressure and temperature. Thus, plots of pressure versus temperature showing the phase in each region provide considerable insights into the thermal properties of substances. Such plots are known as phase diagrams. For instance, in the phase diagram for water (Figure 1), the solid curve boundaries between the phases indicate phase transitions (i.e., temperatures and pressures at which the phases coexist).
7.3K