Related Experiment Video
Updated: Apr 12, 2026

Mechanical Expansion of Steel Tubing as a Solution to Leaky Wellbores
Published on: November 20, 2014
The Effect of Thickness on the Sealing Ability of CEM Cement as a Root-end Filling Material
Saeed Rahimi1, Saeed Asgary2, Mohammad Samiei3
1Dental and Periodontal Research Center, Tabriz University of Medical Sciences, Tabriz, Iran ; Professor, Department of Endodontics, School of Dentistry, Tabriz University of Medical Sciences, Tabriz, Iran.
Abstract:
Background and aims. Different materials have been used for root-end filling during surgical endodontic treatment. The aim of this in vitro study was to evaluate the dye penetration in different thicknesses of calcium enriched mixture (CEM) cement as root-end filling material. Materials and methods. Following root canal filling in 70 extracted human single-rooted premolar teeth, the apical 3 mm of their root-ends was resected; the root-end cavities with depths of 1, 2 and 3 mm were prepared by ultrasonic retrotips and filled with CEM cement. After setting of cement, the roots were immersed in 2% Rhodamine B and the dye leakage was measured under stereomicroscope (×16) using Image J software. The data were analyzed by one-way ANOVA and Bonferroni post hoc tests at 5% significance level. Results. The means and standard deviations of dye penetration in the 1, 2, and 3 mm groups were 3395.5±1893.4, 3410.4±1440.5, and 2581.6±1852.9 μm, respectively. The one-way ANOVA analysis indicated significant differences (P < 0.001); however, the Bonferroni post hoc test revealed that only the positive control group differed significantly from the experimental groups (P < 0.001). Conclusion. The findings demonstrated CEM cement to have an adequate root-end sealing ability in 3-mm thickness.
More Related Videos
06:27Expression of Cementitious Pore Solution and the Analysis of Its Chemical Composition and Resistivity Using X-ray Fluorescence
Published on: September 23, 2018
05:38Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
Related Concept Videos
Porosity in Cement Paste
The balance of water to cement in the mix is...
Pore Size Distribution
Adequate...
Soundness of Cement
Curing of Concrete
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...