Compaction of highly porous granular matter by impacts on a hard wall
Christian Ringl1, Nina Gunkelmann1, Eduardo M Bringa2
1Physics Department and Research Center OPTIMAS, University Kaiserslautern, Erwin-Schrödinger-Straße, D-67663 Kaiserslautern, Germany.
Abstract:
Using a granular-mechanics code, we study the impact of a highly porous granular body on a hard wall. The projectile consists of monodisperse adhesive micrometer-sized silica grains. For the impact velocities studied, v<0.5m/s, the sample does not fragment, but is compacted. We find that the compaction is proportional to the impact speed. The proportionality constant increases with decreasing porosity. However, the compaction is inhomogeneous and decreases with distance from the target. A compaction wave runs through the aggregate; it slows down while the compaction becomes less efficient.
More Related Videos
10:36Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction
Published on: May 20, 2018
07:49Development of an Experimental Setup for the Measurement of the Coefficient of Restitution under Vacuum Conditions
Published on: March 29, 2016
Related Concept Videos
Toughness and Hardness of Aggregate
Impact Strength of Concrete
Impact
When particles with different initial velocities collide, they induce deformation by applying equal and opposite impulses. At the point of maximum deformation, the particles move together with...
Unsoundness of Aggregate due to Volume Change
Porosity in Cement Paste
The balance of water to cement in the mix is...
Compacting Factor test
The procedure begins by placing concrete into the upper hopper without any compaction. Once filled, the bottom door of this hopper is opened,...
