Characterization of polymeric nanomaterials using analytical ultracentrifugation
Related Experiment Video
Updated: Oct 13, 2026

Dispersion of Nanomaterials in Aqueous Media: Towards Protocol Optimization
Published on: December 25, 2017
Leosveys Diaz1, Caroline Peyrot1, Kevin J Wilkinson1
1Department of Chemistry, Biophysical Environmental Chemistry Group, University of Montreal, C.P. 6128, Succursale Centre-ville, Montreal, Quebec, Canada H3C 3J7.
Abstract:
The characterization of nanomaterials represents a complex analytical challenge due to their dynamic nature (small size, high reactivity, and instability) and the low concentrations in the environment, often below typical analytical detection limits. Analytical ultracentrifugation (AUC) is especially useful for the characterization of small nanoparticles (1-10 nm), which are often the most problematic for the commonly used techniques such as electron microscopy or dynamic light scattering. In this study, small polymeric nanomaterials (allospheres) that are used commercially to facilitate the distribution of pesticides in agricultural fields were characterized under a number of environmentally relevant conditions. Under most of the studied conditions, the allospheres were shown to have a constant hydrodynamic diameter (dH) of about 7.0 nm. Only small increases in diameter were observed, either at low pH or very high ionic strength or hardness, demonstrating their high physicochemical stability (and thus high mobility in soils). Furthermore, natural organic matter had little effect on the hydrodynamic diameters of the allospheres. The concentration of the nanoparticles was an important parameter influencing their agglomeration-results obtained using dynamic light scattering at high particle concentrations showed large agglomerate sizes and significant particle losses through sedimentation, clearly indicating the importance of characterizing the nanomaterials under environmentally relevant conditions.
Related Concept Videos
Determination of Molar Masses of Polymers I
Determination of Molar Masses of Polymers II

