A new robust model of one-class classification by interval-valued training data using the triangular kernel

Lev V Utkin1, Anatoly I Chekh2

  • 1Department of Control, Automation and System Analysis, Saint Petersburg State Forest Technical University, Russia.

Related Concept Videos

Prediction Intervals01:03

Prediction Intervals

The interval estimate of any variable is known as the prediction interval. It helps decide if a point estimate is dependable.
However, the point estimate is most likely not the exact value of the population parameter, but close to it. After calculating point estimates, we construct interval estimates, called confidence intervals or prediction intervals. This prediction interval comprises a range of values unlike the point estimate and is a better predictor of the observed sample value, y. 
3.6K
Aggregates Classification01:29

Aggregates Classification

Aggregate classification is generally based on its size, petrographic characteristics, weight, and source. Size classification ranges from coarse to fine aggregates, defined by the size of the particles. Coarse aggregates are particles that do not pass through ASTM sieve No. 4, and aggregates that pass through the sieve are fine aggregates.
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
1.2K
Classification of Systems-II01:31

Classification of Systems-II

Continuous-time systems have continuous input and output signals, with time measured continuously. These systems are generally defined by differential or algebraic equations. For instance, in an RC circuit, the relationship between input and output voltage is expressed through a differential equation derived from Ohm's law and the capacitor relation,
574
Classification of Systems-I01:26

Classification of Systems-I

Linearity is a system property characterized by a direct input-output relationship, combining homogeneity and additivity.
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
684
Quadratic Models01:23

Quadratic Models

Quadratic models are mathematical representations used to describe relationships in which the rate of change changes at a constant rate. These models appear in a wide variety of natural and engineered systems, especially those involving motion, forces, and optimization. One common application is analyzing the vertical motion of objects influenced by gravity, such as a ball thrown into the air.In such scenarios, the object's height changes over time in a curved pattern, rising to a maximum point...
332
Interval Level of Measurement00:55

Interval Level of Measurement

For effective statistical analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
Data measured using the interval scale are similar to ordinal level data because they have a definite arrangement. However, in the interval level of measurement, the differences between data values are meaningful even though the data does not have a starting point.
Temperature is measured using the interval scale. It is measurable data, and the difference between...
20.2K