Estimation of the Environmental Load of High- and Low-Density Polyethylene From South Korea Using a Mass Balance

Mijin Kim1, Seunghun Hyun1, Jung-Hwan Kwon2

  • 1Division of Environmental Science and Ecological Engineering, Korea University, 145 Anam-ro, Seongbuk-gu, Seoul, 136-713, Republic of Korea.

Related Concept Videos

Microbial Bioremediation of Plastics01:28

Microbial Bioremediation of Plastics

Polyethylene terephthalate (PET) is a synthetic polymer widely utilized in the packaging industry, particularly for bottles and containers. Due to its chemical stability and durability, PET accumulates in the environment, contributing significantly to plastic pollution. It comprises repeating units of terephthalic acid and ethylene glycol, resulting in a semi-crystalline structure that is resistant to natural degradation processes.A notable breakthrough in plastic biodegradation came with the...
77
Bioplastics01:27

Bioplastics

Bioplastics derived from microbial processes present a sustainable alternative to conventional petroleum-based plastics. Among these, polyhydroxyalkanoates (PHAs), particularly polyhydroxybutyrates (PHBs), have emerged as prominent candidates due to their biodegradability and biocompatibility. These polymers are synthesized by a variety of bacteria, such as Cupriavidus necator and Pseudomonas putida, which naturally accumulate PHAs as intracellular carbon and energy reserves, especially under...
48
Free-Radical Chain Reaction and Polymerization of Alkenes02:35

Free-Radical Chain Reaction and Polymerization of Alkenes

The conversion of alkenes to macromolecules called polymers is a reaction of high commercial importance. The structure of the polymer is defined by a repeating unit, while the terminal groups are considered insignificant. The average degree of polymerization represents the number of repeating units in the polymer molecule and is denoted by the subscript n.
10.3K
Polymers: Molecular Weight Distribution01:10

Polymers: Molecular Weight Distribution

For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
5.2K
Molecular Weight of Step-Growth Polymers01:08

Molecular Weight of Step-Growth Polymers

Step growth polymerization involves bi or multifunctional monomers. Bifunctional monomers react to form linear step growth polymers, whereas multifunctional monomers react to form non-linear or branched polymers.
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
3.0K
Polymer Classification: Architecture01:14

Polymer Classification: Architecture

Polymers are classified as linear or branched on the basis of their chain architecture. The polymer chains in linear polymers have a long chain-like structure with minimal to no branching at all. Even if a polymer features large substituent groups on the monomer, which appear as branches to the skeleton, it is not considered a branched polymer. A branched polymer contains secondary polymer chains that arise from the main polymer chain. The branching occurs when the polymer growth shifts from...
4.1K