Related Experiment Video
Updated: Apr 6, 2026

Simulation of the Planetary Interior Differentiation Processes in the Laboratory
Published on: November 15, 2013
Diagenesis and clay mineral formation at Gale Crater, Mars
J C Bridges1, S P Schwenzer2, R Leveille3
1Space Research Centre, Department of Physics and Astronomy, University of Leicester Leicester, UK.
Abstract:
The Mars Science Laboratory rover Curiosity found host rocks of basaltic composition and alteration assemblages containing clay minerals at Yellowknife Bay, Gale Crater. On the basis of the observed host rock and alteration minerals, we present results of equilibrium thermochemical modeling of the Sheepbed mudstones of Yellowknife Bay in order to constrain the formation conditions of its secondary mineral assemblage. Building on conclusions from sedimentary observations by the Mars Science Laboratory team, we assume diagenetic, in situ alteration. The modeling shows that the mineral assemblage formed by the reaction of a CO2-poor and oxidizing, dilute aqueous solution (Gale Portage Water) in an open system with the Fe-rich basaltic-composition sedimentary rocks at 10-50°C and water/rock ratio (mass of rock reacted with the starting fluid) of 100-1000, pH of ∽7.5-12. Model alteration assemblages predominantly contain phyllosilicates (Fe-smectite, chlorite), the bulk composition of a mixture of which is close to that of saponite inferred from Chemistry and Mineralogy data and to that of saponite observed in the nakhlite Martian meteorites and terrestrial analogues. To match the observed clay mineral chemistry, inhomogeneous dissolution dominated by the amorphous phase and olivine is required. We therefore deduce a dissolving composition of approximately 70% amorphous material, with 20% olivine, and 10% whole rock component.
More Related Videos
Related Concept Videos
Conditions on Early Earth
Conditions on Early Earth
Porosity in Cement Paste
The balance of water to cement in the mix is...
Gravimetry: Inorganic And Organic Precipitating Agents
Porosity and Absorption of Aggregate
When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the...
Minerals
Major...

