Influence of Light-curing Parameters on Biofilm Development and Flexural Strength of a Silorane-based Composite

The aim of this study was to evaluate the differences in biological and mechanical performances of a silorane-based and a methacrylate-based composite. Another aim was to assess the influence of light-curing time and light-curing intensity on in vitro biofilm formation and flexural strength of the two tested composites.

Experiment 1: 432 specimens obtained from a silorane-based composite and from a standard methacrylate-based composite were divided into six groups and light-cured for 10, 20, 30, 40, 60, or 80 seconds, using one of two light-curing intensities, 400 mW/cm(2) or 800 mW/cm(2). At 24 hours, a monospecific Streptococcus mutans biofilm adherent to the surfaces of the samples was obtained. Then, a colorimetric technique (MTT assay) was used to evaluate the adherent viable biomass. Two samples per group were observed using confocal laser scanning microscopy. Analysis of variance (ANOVA) and Tukey tests were used to analyze the results (p<0.05). Experiment 2: 192 bar-shaped specimens were obtained and light-cured as in the previous experiment. A three-point bend test using a universal testing machine was performed to obtain flexural strength values. ANOVA and Tukey tests were used to analyze the results (p<0.05).

In experiment 1, a highly significant difference (p<0.0001) in biofilm development was shown between silorane-based and methacrylate-based composites. In fact, the silorane-based composite exhibited better biological performance. Significant differences were also found between the two light-curing intensities (p<0.018) and for curing times (p<0.0001): silorane-based composite light-cured for 80 seconds at 800 mW/cm(2) light-curing intensity showed the lowest biofilm development. In experiment 2, a significant difference in flexural strength (p<0.0318) was only found between the different composites. Nevertheless, both resin composites showed flexural strength values in accordance with International Organization for Standardization guidelines even after 10 seconds of light-curing time.

Silorane-based composite was less prone to biofilm development compared with a methacrylate-based composite. Acceptable flexural strength values for both composites were obtained after 10 seconds of light-curing time.