Related Experiment Video
Updated: Apr 4, 2026

Spectrophotometric Screening for Potential Inhibitors of Cytosolic Glutathione S-Transferases
Published on: October 10, 2020
The Reliability of Estimating Ki Values for Direct, Reversible Inhibition of Cytochrome P450 Enzymes from
Lois J Haupt1, Faraz Kazmi1, Brian W Ogilvie1
1XenoTech, LLC, Lenexa, Kansas (L.J.H., F.K., B.W.O., D.B.B., B.D.S., S.L.); and XPD Consulting, Shawnee, Kansas (B.P., O.P., A.P.).
Abstract:
In the present study, we conducted a retrospective analysis of 343 in vitro experiments to ascertain whether observed (experimentally determined) values of Ki for reversible cytochrome P450 (P450) inhibition could be reliably predicted by dividing the corresponding IC₅₀ values by two, based on the relationship (for competitive inhibition) in which Ki = IC₅₀/2 when [S] (substrate concentration) = Km (Michaelis-Menten constant). Values of Ki and IC₅₀ were determined under the following conditions: 1) the concentration of P450 marker substrate, [S], was equal to Km (for IC₅₀ determinations) and spanned Km (for Ki determinations); 2) the substrate incubation time was short (5 minutes) to minimize metabolism-dependent inhibition and inhibitor depletion; and 3) the concentration of human liver microsomes was low (0.1 mg/ml or less) to maximize the unbound fraction of inhibitor. Under these conditions, predicted Ki values, based on IC₅₀/2, correlated strongly with experimentally observed Ki determinations [r = 0.940; average fold error (AFE) = 1.10]. Of the 343 predicted Ki values, 316 (92%) were within a factor of 2 of the experimentally determined Ki values, and only one value fell outside a 3-fold range. In the case of noncompetitive inhibitors, Ki values predicted from IC₅₀/2 values were overestimated by a factor of nearly 2 (AFE = 1.85; n = 13), which is to be expected because, for noncompetitive inhibition, Ki = IC₅₀ (not IC₅₀/2). The results suggest that, under appropriate experimental conditions with the substrate concentration equal to Km, values of Ki for direct, reversible inhibition can be reliably estimated from values of IC₅₀/2.
More Related Videos
Related Concept Videos
Determination of Michaelis Constant and Maximum Elimination Rate
These parameters can be estimated by analyzing plasma concentration data post-drug administration. A notable example of this application is phenytoin, a drug with capacity-limited kinetics. It's recommended that phenytoin should be administered at two...
One-Compartment Open Model: Wagner-Nelson and Loo Riegelman Method for ka Estimation
On...
Introduction to Enzyme Kinetics
The experimenter can then plot the initial reaction rate or velocity (Vo) of a given trial against the substrate concentration ([S]) to obtain a graph of the reaction properties. For many enzymatic reactions involving a...
Nonlinear Pharmacokinetics: Michaelis-Menten Equation
Vmax represents the maximum achievable process rate, while KM, known as the Michaelis constant, signifies the drug concentration at which the process rate reaches half its maximum. This relationship between Vmax, KM, and Cp gives rise to three distinct...
Pharmacogenetics of Phase I Enzymes: Cytochrome P450 Isozymes
Enzyme Kinetics
Scientists typically study enzyme kinetics with a fixed amount of enzyme in the controlled environment of a test tube. When more reactant, or substrate, is...

