Related Experiment Video

Updated: Apr 3, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

6.7K

Dual wavelength 3.2-μm source for isotope ratio measurements of (13)CH(4)/(12)CH(4)

Masashi Abe, Satomi Kusanagi, Yoshiki Nishida

    Optics Express
    |September 15, 2015
    PubMed

    More Related Videos

    Coulomb Explosion Imaging as a Tool to Distinguish Between Stereoisomers08:51

    Coulomb Explosion Imaging as a Tool to Distinguish Between Stereoisomers

    Published on: August 18, 2017

    11.1K
    Preparing an Isotopically Pure 229Th Ion Beam for Studies of 229mTh10:42

    Preparing an Isotopically Pure 229Th Ion Beam for Studies of 229mTh

    Published on: May 3, 2019

    7.4K

    Related Concept Videos

    ¹³C NMR: ¹H–¹³C Decoupling01:04

    ¹³C NMR: ¹H–¹³C Decoupling

    The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
    A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
    2.1K
    Mass Spectrometry: Isotope Effect01:13

    Mass Spectrometry: Isotope Effect

    Most elements exist in nature as a mixture of isotopes. The isotopes differ in weight due to their respective number of neutrons. The molecular weight of a molecule is different depending on the specific isotope of its elements involved. As a result, the mass spectrum of the molecule exhibits peaks from the same fragment at multiple positions. The positions of these mass signals depend on the mass differences between isotopes. Furthermore, the intensity of these signals is dependent on the...
    5.0K
    Mass Spectrum: Interpretation01:24

    Mass Spectrum: Interpretation

    An unknown compound can be established by identifying the molecular ion peak in the mass spectrum. The molecular ion peak is often weak or absent due to the predominance of fragmentation in high-energy electron beams. In such cases, a soft-energy electron beam can be used to scan the spectrum to enhance the intensity of the molecular ion peak. Additionally, chemical ionization, field ionization, and desorption ionization spectra are used to obtain a relatively intense molecular ion peak.To...
    4.3K
    2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)01:19

    2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)

    Heteronuclear single-quantum correlation spectroscopy (HSQC) is a 2D NMR technique that reveals one-bond correlations between hydrogen and a heteronucleus. The HSQC experiment is similar to the heteronuclear correlation experiment (HETCOR) but is more sensitive. In the HSQC spectrum, the proton chemical shift is plotted on the horizontal F2 axis, while the 13C chemical shift is plotted on the vertical F1 axis. The corresponding proton and 13C spectra are also shown. The HSQC contour plot does...
    1.6K
    Atomic Absorption Spectroscopy: Instrumentation01:22

    Atomic Absorption Spectroscopy: Instrumentation

    An atomic absorption spectrophotometer (AAS) comprises several components: a radiation source, an atomizer, a monochromator, and a detector. The radiation source can be a hollow-cathode lamp (HCL) or an electrodeless-discharge lamp (EDL), both of which provide a narrow emission line of the required wavelength. However, some instruments use continuum sources and high-resolution monochromators to achieve a narrow range of radiation.
    The atomizer used in AAS can be either a flame atomizer or an...
    2.1K
    Atomic Absorption Spectroscopy: Radiation and Light Sources01:13

    Atomic Absorption Spectroscopy: Radiation and Light Sources

    Atomic absorption spectroscopy (AAS) relies on the Beer-Lambert law, which requires that the radiation source emits a narrow range of wavelengths to match the absorption characteristics of the analyte atom. The primary criteria for choosing an appropriate radiation source in AAS is to provide a precise and intense emission at specific wavelengths that will allow accurate detection of the analyte.
    Two common narrow-range 'line' sources used in AAS are hollow-cathode lamps (HCLs) and...
    1.6K