Related Experiment Video

Updated: Apr 3, 2026

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids
11:03

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids

Published on: December 4, 2017

9.1K

Environmental coherence and excitation effects in non-Markovian dynamics

Ying Liu, Wen Cheng, Ze-Yu Gao

    Optics Express
    |September 15, 2015
    PubMed

    More Related Videos

    Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis06:44

    Age-dependent Dynamics of Locomotion in Caenorhabditis elegans: A Lyapunov Exponent Analysis

    Published on: September 23, 2025

    689
    Simultaneous Long-term Recordings at Two Neuronal Processing Stages in Behaving Honeybees13:55

    Simultaneous Long-term Recordings at Two Neuronal Processing Stages in Behaving Honeybees

    Published on: July 21, 2014

    13.6K

    Related Concept Videos

    Entropy Changes Accompanying Specific Processes01:21

    Entropy Changes Accompanying Specific Processes

    Entropy, a measure of disorder in a system, changes during phase transitions like freezing or boiling. At the transition temperature Ttrs, where two phases are in equilibrium, the phase transition is a reversible process. The entropy change can be calculated from a substance's enthalpy of transition using the equation ΔStrs = ΔtrsH /Ttrs.When a perfect gas expands isothermally from one volume to another, entropy increases logarithmically with volume. Conversely, isothermal compression...
    101
    Entropy Change in Reversible Processes01:10

    Entropy Change in Reversible Processes

    In the Carnot engine, which achieves the maximum efficiency between two reservoirs of fixed temperatures, the total change in entropy is zero. The observation can be generalized by considering any reversible cyclic process consisting of many Carnot cycles. Thus, it can be stated that the total entropy change of any ideal reversible cycle is zero.
    The statement can be further generalized to prove that entropy is a state function. Take a cyclic process between any two points on a p-V diagram.
    3.4K
    Atomic Nuclei: Nuclear Relaxation Processes01:23

    Atomic Nuclei: Nuclear Relaxation Processes

    In the absence of an external magnetic field, nuclear spin states are degenerate and randomly oriented. When a magnetic field is applied, the spins begin to precess and orient themselves along (lower energy) or against (higher energy) the direction of the field. At equilibrium, a slight excess population of spins exists in the lower energy state. Because the direction of the magnetic field is fixed as the z-axis,  the precessing magnetic moments are randomly oriented around the z-axis.
    1.4K
    Propagation of Action Potentials01:23

    Propagation of Action Potentials

    The propagation of an action potential refers to the process by which a nerve impulse, or "action potential," travels along a neuron.
    Neurons (nerve cells) have a resting membrane potential, with a slightly negative charge inside compared to outside. This is maintained by ion channels, such as sodium (Na+) and potassium (K+) channels, which control the flow of ions. When a stimulus, like a touch or a signal from another neuron, triggers the neuron, sodium channels open, allowing sodium ions to...
    14.2K
    Inductive Effects on Chemical Shift: Overview01:27

    Inductive Effects on Chemical Shift: Overview

    The protons in unsubstituted alkanes are strongly shielded with chemical shifts below 1.8 ppm. Methine, methylene, and methyl protons appear at approximately 1.7, 1.2 and 0.7 ppm, while the proton signal from methane appears at 0.23 ppm. An electronegative substituent, such as chlorine, withdraws the electron density from the protons, increasing their chemical shift. Progressive substitution of the hydrogens in methane by chlorine shifts the proton signals increasingly downfield, to 3.05 ppm in...
    2.5K
    Stability of Equilibrium Configuration01:23

    Stability of Equilibrium Configuration

    Understanding the stability of equilibrium configurations is a fundamental part of mechanical engineering. In any system, there are three distinct types of equilibrium: stable, neutral, and unstable.
    A stable equilibrium occurs when a system tends to return to its original position when given a small displacement, and the potential energy is at its minimum. An example of a stable equilibrium is when a cantilever beam is fixed at one end and a weight is attached to the other end. If the weight...
    951