Related Experiment Video
Updated: Apr 3, 2026

Preparation and Friction Force Microscopy Measurements of Immiscible, Opposing Polymer Brushes
Published on: December 24, 2014
Elasticity of frictionless particles near jamming
Kamran Karimi1, Craig E Maloney1
1Department of Civil and Environmental Engineering, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213, USA.
Abstract:
We study the linear elastic response of harmonic disk packings near jamming via three types of probes: (i) point forcing, (ii) constrained homogeneous deformation of subregions of large systems, and (iii) unconstrained deformation of the full system subject to periodic boundary conditions. For the point forcing, our results indicate that the transverse component of the response is governed by a lengthscale ξT, which scales with the confining pressure, p, as ξT∼p-0.25, while the longitudinal component is governed by ξL, which scales as ξL∼p-0.4. The former scaling is precisely the transverse lengthscale, which has been invoked to explain the structure of normal modes near the density of states anomaly in sphere packings, while the latter is much closer to the rigidity length, l*∼p-0.5, which has been invoked to describe the jamming scenario. For the case of constrained homogeneous deformation, we find that μ(R), the value of the shear modulus measured in boxes of size R, gives a value much higher than the continuum result for small boxes and recedes to its continuum limit only for boxes bigger than a characteristic length, which scales like p-0.5, precisely the same way as l*. Finally, for the case of unconstrained homogeneous deformation, we find displacement fields with power spectra, which are consistent with independent, uncorrelated Eshelby transformations. The transverse sector is amazingly invariant with respect to p and very similar to what is seen in Lennard-Jones glasses. The longitudinal piece, however, is sensitive to p. It develops a plateau at long wavelength, the start of which occurs at a length that grows in the p→0 limit. Strikingly, the same behavior is observed both for applied shear and dilation.
More Related Videos
08:58Atomic Force Microscopy Cantilever-Based Nanoindentation: Mechanical Property Measurements at the Nanoscale in Air and Fluid
Published on: December 2, 2022
07:49Development of an Experimental Setup for the Measurement of the Coefficient of Restitution under Vacuum Conditions
Published on: March 29, 2016
Related Concept Videos
Frictional Force
Static and Kinetic Frictional Force
However, if two systems are in contact and are stationary relative to one...
Types of Friction Problems
The first type of dry friction problem involves situations where there is no apparent impending motion....
Static Friction
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...
Kinetic Friction
Dry Friction
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...