Related Experiment Video

Updated: Apr 3, 2026

Scattering And Absorption of Light in Planetary Regoliths
11:34

Scattering And Absorption of Light in Planetary Regoliths

Published on: July 1, 2019

11.1K

The diurnal cycle of water ice on comet 67P/Churyumov-Gerasimenko

M C De Sanctis1, F Capaccioni1, M Ciarniello1

  • 1Istituto di Astrofisica e Planetologia Spaziali - INAF, via del fosso del cavaliere 100, 00133 Rome, Italy.

Nature
|September 25, 2015
PubMed

More Related Videos

Laser-Induced Fluorescence Emission L.I.F.E. as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats13:38

Laser-Induced Fluorescence Emission L.I.F.E. as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats

Published on: October 26, 2019

8.6K
Manufacturing Simple and Inexpensive Soil Surface Temperature and Gravimetric Water Content Sensors08:49

Manufacturing Simple and Inexpensive Soil Surface Temperature and Gravimetric Water Content Sensors

Published on: December 21, 2019

10.4K

Related Concept Videos

The Water Cycle01:00

The Water Cycle

The Earth’s hydrosphere includes all of the areas where the storage and movement of water occurs. Since water is the basis of all living processes, the cycling of water is extremely important to ecosystem dynamics.
29.5K
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
58.3K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.7K
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
20.9K
Precipitation Gravimetry01:03

Precipitation Gravimetry

Precipitation gravimetry is based on converting an analyte into a sparingly soluble precipitate, which is separated by filtration and weighed. An ideal precipitate should be pure, insoluble, of known composition, and easily filtered from the reaction mixture.
In determining nickel by gravimetric analysis, a precipitant of ethanolic dimethylglyoxime is added to a hot nickel salt solution. This is quickly followed by the dropwise addition of dilute ammonia solution until precipitation occurs. A...
16.1K
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
6.5K