Related Concept Videos

Cell Motility through Blebbing01:16

Cell Motility through Blebbing

Blebs are a type of membrane protrusion formed by the internal hydrostatic pressure of the cytoplasm. Blebs are observed in several cell types, including fibroblasts, immune cells, and single-celled organisms like the amoeba. The primary function of blebs is cell locomotion and apoptosis, but they are also found during necrosis and cell division. The life cycle of a bleb comprises an initiation phase followed by the expansion and retraction phases.
Blebbing Through the Matrix
In multicellular...
2.7K
Polarity of the Cytoskeleton01:18

Polarity of the Cytoskeleton

The intrinsic polarity of cells can be primarily attributed to two factors- i) the asymmetric accumulation of mobile components such are regulatory molecules and subcellular components across the cell and ii) the orientation of polar cytoskeletal filaments that make up the cytoskeletal networks, specifically microfilaments, and microtubules arranged along the axis of polarity. Interactions between the cytoskeletal filaments are crucial for the establishment and maintenance of the polar nature...
25.6K
Symmetry01:26

Symmetry

The equation of an ellipse centered at the origin defines all points whose distances from the center maintain a constant ratio between the horizontal and vertical axes. This equation results in a smooth, closed curve that extends further along the x-axis than the y-axis, giving it a horizontal orientation. Such an ellipse demonstrates three kinds of symmetry: across the x-axis, across the y-axis, and about the origin. These symmetries are essential in understanding the graph's structure and...
379
Plastic Deformations of Members with a Single Plane of Symmetry01:21

Plastic Deformations of Members with a Single Plane of Symmetry

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...
449
Cleavage and Blastulation01:33

Cleavage and Blastulation

After a large-single-celled zygote is produced via fertilization, the process of cleavage occurs while zygotes travel through the uterine tube. Cleavage is a mitotic cell division that does not result in growth. With each round of successive cell division, daughter cells get increasingly smaller.
51.4K
Gauss's Law: Planar Symmetry01:27

Gauss's Law: Planar Symmetry

A planar symmetry of charge density is obtained when charges are uniformly spread over a large flat surface. In planar symmetry, all points in a plane parallel to the plane of charge are identical with respect to the charges. Suppose the plane of the charge distribution is the xy-plane, and the electric field at a space point P with coordinates (x, y, z) is to be determined. Since the charge density is the same at all (x, y) - coordinates in the z = 0 plane, by symmetry, the electric field at P...
10.2K