Related Experiment Video
Updated: Apr 1, 2026

Effects of a Novel Neuromuscular Training Intervention on Jump, Sprint, and Change of Direction in Adult Female Soccer Players
Published on: June 10, 2025
Reactive Strength Index Modified Is a Valid Measure of Explosiveness in Collegiate Female Volleyball Players
Kristof Kipp1, Michael T Kiely, Christopher F Geiser
1Department of Physical Therapy, Marquette University, Milwaukee, Wisconsin.
Abstract:
The purpose of this study was to investigate the validity of the reactive strength index modified (RSImod) as a measure of lower body explosiveness. Fifteen female, National Collegiate Athletic Association Division I volleyball players performed vertical countermovement jumps (CMJs) while standing on a force plate. Each player performed 3 CMJs. The vertical ground reaction forces collected during each jump were used to calculate jump height, time to take-off, time to peak force, peak force, peak rate of force development, and peak power; the latter 3 variables were all normalized to body mass. Reactive strength index modified was calculated as the ratio between jump height and time to take-off. All variables, except for jump height, were then entered a factor analysis, which reduced the input data into 2 factors: a force factor and a speed factor. Although RSImod loaded more strongly onto the force factor, further analysis showed that RSImod loaded positively onto both force and speed factors. Visual analysis of the Cartesian coordinates also showed that RSImod loaded into the quadrant of greater force and speed abilities. These results indicate that the construct of RSImod, as derived from CMJ force-time data, captures a combination of speed-force factors that can be interpreted as lower body explosiveness during the CMJ. Reactive strength index modified therefore seems to be a valid measure to study lower body explosiveness.
Related Concept Videos
Impact Strength of Concrete
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
Factors Affecting Activity Coefficient
The activity coefficient value for an ion is close to one when the solution has almost zero ionic strength, i.e., when the solution shows close to ideal behavior. As the ionic strength of the solution increases from 0 to 0.1 mol/L, a...
Impact Loading
In cases of elastic deformation,...
Ionic Strength: Overview

