Human response to vibration stress in Japanese workers: lessons from our 35-year studies A narrative review

Tsunetaka Matoba1

  • 1Kurume University School of Medicine, Japan.

Industrial Health
|October 14, 2015
PubMed

Related Concept Videos

Stress Concentrations in Circular Shafts01:18

Stress Concentrations in Circular Shafts

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...
668
Psychological Responses to Stress01:20

Psychological Responses to Stress

Psychological responses to stress encompass the various cognitive and emotional reactions individuals experience when faced with challenging or threatening situations, such as a job loss. Prolonged exposure to stressors can disturb emotional balance, increasing negative emotions (e.g., anxiety and sadness) and diminishing positive emotions (e.g., joy and satisfaction). These persistent emotional shifts are associated with an increased risk of both physical illness and mental health issues, such...
876
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
820
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
777
Responses to Heat and Cold Stress02:45

Responses to Heat and Cold Stress

Every organism has an optimum temperature range within which healthy growth and physiological functioning can occur. At the ends of this range, there will be a minimum and maximum temperature that interrupt biological processes.
15.7K
Stress Response System01:21

Stress Response System

The stress response system, also known as the fight-or-flight response, is the body's automatic physiological reaction to perceived threats. Hans Selye introduced the concept of General Adaptation Syndrome (GAS) to describe the predictable pattern of changes that occur in response to stress. GAS consists of three sequential stages: alarm, resistance, and exhaustion. This model helps explain how chronic stress can contribute to health problems.
Alarm stage
In the alarm stage, the body's...
1.1K